Toolland WEH300 handleiding
Handleiding
Je bekijkt pagina 12 van 84
WEH200/WEH300
V. 07 – 24/06/2021 12 ©Velleman nv
• When the steel cable has been unwound as far as possible, the lever for the maximum
cable length will be actuated. The motor must then stop.
• Inspect the mains cable and the control cable periodically.
• The steel cable and return roller must be greased every 200 cycles.
• Check every 1000 cycles whether the screws for the fastening clamps and return roller are
properly tightened.
• Check every 1000 cycles whether the hooks and return roller are in good condition.
• Check before using the appliance whether the emergency stop switch and pushbuttons are
in perfect working order.
• Check the braking system every 1000 cycles. If the motor makes any unusual noises or
cannot raise the rated load, it is possible that the braking system requires an overhaul:
o Replace damaged or worn parts and keep the service documentation relating to this in
a safe place.
o Please contact an authorized service centre for any unscheduled maintenance work.
Storage
• Store the appliance and its accessories out of the reach of children, in a dark and dry place
at above freezing temperature. The ideal storage temperature is between 5 and 30 °C.
Store the appliance in its original packaging.
9. Troubleshooting
Malfunction
Cause
Solution
The on-off switch does not
work.
It is not plugged into the
power supply.
Connect to the power supply.
The wires are broken or
ripped.
Check the wires and re-
connect to the power supply.
Switch malfunction.
Repair switch or change it.
The capacitor is burned
through.
Change your capacitor.
End-switch has not been reset
or a limit switch error.
Check the end-switch and
replace the limit switch.
The thermal switch has
suffered a wire break.
Wait until the item cools down
or replace the thermal switch.
The dual-direction switch has
been activated. The motor is
very loud but cannot pick-up
the load.
The voltage offered is too
small.
Adjust the work, depending
on the power supply.
The capacitor has become
damaged.
Change power supply.
The brake is not completely
open.
Allow the appliance to be
repaired from a qualified
repair service.
After a power loss the brakes
do not hold or the appliance
slips down.
The gap between the brakes
is too large.
Allow the appliance to be
repaired from a qualified
repair service.
The brake spring is ripped.
The brake disk is locked.
The brake disk is dirty.
The noise of the machine
becomes louder
Badly oiled.
Oil/Grease the appliance.
After a long use, the
cogwheel and bearings are
damaged.
Change the cogwheel or
bearings.
Badly installed or dent.
Check the installed parts.
Bekijk gratis de handleiding van Toolland WEH300, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Toolland |
| Model | WEH300 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 14586 MB |
