Theben RMG 8 T KNX handleiding
Handleiding
Je bekijkt pagina 56 van 87
MIX 2 series RMG 8 T / RME 8 T actuators
Continuation:
Designation
Values
Description
On receipt of a step/stop
command
Process immediately
(recommended)
Every received step command is carried
out immediately
Wait 0.3 s to see if an UP/DOWN
command follows
Wait 0.4 s to see if an UP/DOWN
command follows
Wait 0.5 s to see if an UP/DOWN
command follows
Step commands are only executed if no
operating command is received within
the set time.
These settings apply to push buttons
which, when pressed and held, first send
a step command and then an operating
command.
Tighten fabric (awning)
yes
Only for roller blinds/awning/general
drive.
At values above 70%, the hanging,
awning or roller blind will be
retightened by moving back briefly.
On roller blinds it is guaranteed that the
vent slots will remain open.
no
No tensioning.
Pause time before
reversal of direction
0.5 s
1 s
2 s
3 s
Pause introduced to protect the drive
motor against conflicting commands
(e.g. if a descend command is received
while ascending).
This setting depends on the information
supplied by the manufacturer of the
drive
Automatic execution of
the slat object value
[%] after the height
object [%]
yes
no
Selection whether or not the slat position
(according to the slat object % slat) is to
be resumed after the height adjustment
via the height object % Height.
Assignment of the 0%
position to the slat
objects [%]
0% corresponds to slat position
on lowering
0% corresponds to slat position
on ascending
Input of the starting position for the
calculations of the slat turn.
Participation in central
Up/Down object
yes
no
Should the drive respond to the central
object?
Transmission of feedback
only at change
cyclically and at change
When should feedback
(Obj. Slat feedback and Height
feedback) be sent?
Time for cyclical
transmission of feedback
2 minutes, 3 minutes,
5 minutes, 10 minutes,
15 minutes, 20 minutes,
30 minutes, 45 minutes
60 minutes
If cyclically, at what interval?
Version: May-14 (Subject to change) Page 56 of 87
Bekijk gratis de handleiding van Theben RMG 8 T KNX, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Theben |
| Model | RMG 8 T KNX |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 11185 MB |
