Thames & Kosmos Gravity Bugs - Free-Climbing MicroBot handleiding
Handleiding
Je bekijkt pagina 13 van 20
STEPS
28 – 31
11
Gravity Bugs
28
29
Insert a AAA battery with the correct
polarity. To cover, slide the tabs of part 23
into the slots in the battery compartment.
Remove the second alignment tool
(part 11).
Use the half-
threaded screw
(P8) to secure
the cover to
the battery
compartment.
AAA
x1
23
Turn it on!
Turn on the switch to make sure the gears turn.
The four gray circular columns on each side of the
body should now be moving in unison.
If the columns don’t turn smoothly, something
is misaligned in the gearbox. Don’t stress! Take
it apart, then try to figure it out as you rebuild it.
This is part of the fun of engineering!
Make sure you’ve removed all of the burrs from
the gears.
P8
11
!
Do not over-tighten
the screws.
30
31
Note the and polarity
markings on the battery
compartment.
Don’t
over-tighten the
screws. If the
gears don’t turn
when you test it
in step 30,
loosen these
screws a little.
P7
P7
Insert two more fully threaded screws into
the body as shown and tighten.
Bekijk gratis de handleiding van Thames & Kosmos Gravity Bugs - Free-Climbing MicroBot, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Thames & Kosmos |
| Model | Gravity Bugs - Free-Climbing MicroBot |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 13071 MB |
