Thames & Kosmos Gravity Bugs - Free-Climbing MicroBot handleiding

Niet gecategoriseerd

Thames & Kosmos

20 pagina's

PDF beschikbaar

Handleiding

Sandpaper

STEPS

23 – 27

Place two part 10 gears as shown. Remove

any burrs with sandpaper.

Place two part 9 gears as shown into

subassembly D. Remove any burrs with

sandpaper.

Insert one fully threaded screw through the

hole in part 14, then tighten the screw.

Next, remove part 14.

Carefully place the upper body half onto

the lower body half.

Place two part 12 gears, with the teeth

facing up, on the blue pegs as shown.

Make sure the

circular columns

of part 10 are

pointed up and

oriented toward

the center of the

gearbox.

Do not over-tighten

the screw.

Make sure the

grooves on the

upper body

half slide onto

the tabs of the

battery box.

Press the gears firmly into place.

Remove the

alignment

tool, lifting

straight up to

not disturb

the gears.

Check the gears:

The teeth of part 10 should mesh with the teeth

of part 12. The gears will not turn at this point

because they are locked in place.

Bekijk gratis de handleiding van Thames & Kosmos Gravity Bugs - Free-Climbing MicroBot, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.