Thames & Kosmos Fuel Cell 10: Car & Experiment Kit handleiding
Handleiding
Je bekijkt pagina 25 van 68
Do It! Assemble the Display Stand
Do It! Install the Gas Tanks
Assembling the Display Stand
with Rollers
Initial Assembly Chapter 2
1
Fuel Cell 10
23
Experiment Manual
2
Rubber Feet
Check to make sure the three
rubber feet are attached to
the underside of the base
plate. These provide a more
stable footing for the display
stand.
Axles and Pulley
Transmission
Start sliding the short axle
with shaft stop into axle
holder 1. Carefully position
the rubber belt and the first
pulley wheel in the groove
between the two sides of the
axle holder so that the axle
slides through both of them as
it passes through the groove.
The pulley wheel should en-
gage securely to the axle at
the axle stop.
Put roller caps on both ends of
the first axle.
Pulley Wheel
Note: This assembly is intended to be permanent.
INFO:
The feet
come pre-
attached.
Stop
Short Axle
Roller Cap
Pulley Wheel 1
Rubber Transmission Belt
Groove
Stop
Axle Holder 1
Axle Holder 2
Axle Holder 3
Fuel Cell 10 Manual.indd 23 8/4/09 9:11:47 PM
Bekijk gratis de handleiding van Thames & Kosmos Fuel Cell 10: Car & Experiment Kit, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Thames & Kosmos |
| Model | Fuel Cell 10: Car & Experiment Kit |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 57508 MB |
