Tenda EE3 Pro handleiding
Handleiding
Je bekijkt pagina 36 van 159
29
Document version: V1.0
6) If the Address Type is Static IP Address, enter IP Address, Subnet Mask, Gateway, Primary
DNS, and Secondary DNS provided by your ISP.
If your ISP provides only one DNS server, you can leave Secondary DNS blank.
9. If your ISP has provided you with other parameters, refer to the following settings.
1) Click Advanced.
2) For PPPoE or Russia PPPoE, if your ISP requires a server name, service name, enter it in the
Server Name, Service Name field.
3) (Optional) To set a specific MTU size for an Internet connection, specify the MTU size in
the MTU field.
MTU specifies the largest data packet transmitted by a network device. Do not change the
value unless:
− Your ISP or our technical support suggests you change it when you have problems
connecting to your ISP or other internet services.
− You use VPN and encounter serious performance problems.
− You used a program to optimize MTU for performance reasons, and now you have
connectivity or performance problems.
− A wrong/improper MTU value may cause internet communication problems. For example,
you may be unable to access certain websites, frames within websites, secure login pages,
FTP or POP servers.
The MTU value range is as follows:
− When the internet connection type is PPPoE, the default value is 1480. Its allowed range is
1280 to 1492.
− When the internet connection type is dynamic IP or static IP, the default value is 1500. Its
allowed range is 1280 to 1500.
− When the internet connection type is PPTP/L2TP, the default value is 1400. Its allowed
range is 1280 to 1460.
4) (Optional) Specify the MAC address of the WAN port of primary node in the MAC Address
Clone field.
If the primary node cannot be connected to the internet after internet settings, the reason may
be that the ISP binds internet access information to a MAC address. At this point, perform MAC
address clone and try to surf the internet.
− Default MAC: Keep the factory setting of MAC address.
− Clone Local Host MAC: Set the MAC address of the primary node to the same as that of the
device which is configuring the node.
Bekijk gratis de handleiding van Tenda EE3 Pro, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Tenda |
| Model | EE3 Pro |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 24960 MB |
