TC Electronic MD4 HD handleiding
Handleiding
Je bekijkt pagina 8 van 22
8 MD4 HD NATIVE User Manual
5.2 Main Page
Input (orange controls)
Normalizer Gain
Range: -18 dB to +18 dB in 0.1 dB steps
The Normalizer Gain is the rst gain stage in the plugin, used to adjust the overall
level of the input signal.
Trim Gain (L/R or M/S)
Range: -12 dB to +12 dB in 0.1 dB steps
Trim the gain level for the two input channels to the EQ.
When using the EQ section, the gain might have been increased or decreased. The
Trim Gains are used to optimize the gain before reaching the Compressor section.
5 Band Compressor Setup (green controls)
Conguration
Options: Stereo, Mid/Side
Stereo
In Stereo Mode, the Compressor section of the algorithm uses by default one
common Sidechain for both Left and Right channels, and the EQ section is linked.
It can be unlinked.
The gain reduction meters show the left and right channels.
Mid/Side (MS)
In this mode, the MS encoder is activated. The Compressor section of the
algorithm uses Sidechains as follows:
• • When COM LINK is enabled, there is only one Sidechain.
• • When COM LINK is disabled there is a separate Sidechain for the Mid and
Side channel.
EQ can be linked or unlinked.
In Mid/Side mode, the left meter shows the Mid channel, and the right meter
shows the Side channel.
NOTE : When a mono signal is processed, only the left channel of the algorithm
is active
Mode
Range: Normal, Parallel, Parallel Unlinked, DXP
Select Normal for downward compression
Select Parallel for upward compression. By default (Wet Gain 0 dB), the dry and
compressed signals are added in equal parts and then compensated by -6 dB.
This results in a neutral gain when the compressor is not actively reducing the
signal. The contribution of the Compressor signal can be adjusted using Wet Gain
(see the Compressor Page).
Select Parallel UL for upward compression with unlinked compressor. This works
just like Parallel, except that the two channels (L/R or M/S) are compressed
independently, so peaks on one channel don't lead to gain reduction on the other
channel. Beware that this can lead to changing the stereo image, although this
is not as noticable in Parallel mode, because the dry signal still preserves the
original stereo image.
NOTE: in M/S Unlinked conguration, Parallel and Parallel UL are identical.
Select DXP compression for lifting up low levels without touching transients. This
mode introduces a new parameter on each band: Steer, instead of Threshold.
Steer determines the slope and boost of that particular band. Bands hit unity gain
(0 dB gain) at the Reference Level, so low-level boosting only takes place below
that level, and is at the max below each band’s Threshold.
Bekijk gratis de handleiding van TC Electronic MD4 HD, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | TC Electronic |
| Model | MD4 HD |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 8045 MB |
