Supermicro X14SBH-AP handleiding
Handleiding
Je bekijkt pagina 54 van 140
NVMe I²C Headers
Connectors JNVI²C1 and JNVI²C2 on the X14SBH-AP motherboard are the NVMe hot-swap
management headers for the Supermicro NVMe backplane. Connect the I²C cable to these
connectors.
For a detailed diagram of the X14SBH- AP motherboard, see the layout under "Quick
Reference" on page 12.
NVMe I²C
Pin Definitions: Four Total
Pin# Definition
1 Data
2 Ground
3 CLK
4 +3.3 V
TPM/Port 80 Header
The JTPM1 header on the X14SBH-AP motherboard is used to connect a Trusted Platform
Module (TPM)/Port 80, which is available from Supermicro (optional). A TPM/Port 80 connector
is a security device that supports encryption and authentication in hard drives. It allows the
motherboard to deny access if the TPM associated with the hard drive is not installed in the
system. Information on the TPM is available at the following page:
https://www.supermicro.com/en/products/accessories/addon/AOM-TPM-9672V.php
For a detailed diagram of the X14SBH- AP motherboard, see the layout under "Quick
Reference" on page 12.
Trusted Platform Module Header
Pin Definitions: 10 Total
Pin# Definition Pin# Definition
1 +3.3 V 2 SPI_CS#
3 RESET# 4 SPI_MISO
5 SPI_CLK 6 Ground
7 SPI_MOSI 8 No Connection
9 +1.8 V Standby 10 SPI_IRQ#
Universal Serial Bus (USB) Header
There is one USB 3.2 Gen 1 header located at USB2/3 on the X14SBH-AP motherboard.
54
X14SBH-AP: Component Installation
Bekijk gratis de handleiding van Supermicro X14SBH-AP, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Supermicro |
| Model | X14SBH-AP |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 17647 MB |
