Supermicro Blade SBI-621E-1NE38 handleiding

Niet gecategoriseerd

Supermicro

61 pagina's

PDF beschikbaar

Handleiding

18 19

Chapter 2: Installation and Setup Chapter 2: Installation and Setup

2.2 Powering Up or Down

Each blade unit may be powered on and o󰀨 independently from the rest of the blades in the

enclosure. A blade unit may be powered down or up in any of the following ways:

• Press the power button on the blade unit.

• Use IPMIView or the browser based management utility to power down; requires Operator

or Admin privileges on the CMM.

• Use SMCIPMItool when connected to the CMM to power down; requires Operator or Admin

privileges on the CMM.

• Use IPMIview or a browser connected to the onboard BMC chip to power down.

• Use SMCIPMItool to use a Command Line Interface to the onboard BMC chip; requires

Operator or Admin privileges.

Removing a Blade Unit from the Enclosure

A blade can be removed from the enclosure while other blades continue to operate.

Note: When a blade is removed, ensure the slot is covered with a dummy blade/chassis to

ensure the neighboring blade does not overheat.

Removing a Blade Unit from the Enclosure

1. Power down the blade unit.

2. Push and hold the two locking levers out and away from each other.

3. Use the locking levers to pull the blade from the enclosure.

Figure 2-1. Blade Locking Levers

(SBI-621E-1NE38 model shown; see Figure 1-1 for SBI-621E-1NE34 lever locations.)

2.1 Installing or Removing the Blade Unit

Installing a Blade Unit into the Enclosure

1. Pull the locking levers out and apart, and push the blade into its bay. Caution: Insert the

blade carefully so the rear connectors are not damaged.

2. As the blade is seated in the enclosure, push the levers into their locked position.

Locking Levers

Bekijk gratis de handleiding van Supermicro Blade SBI-621E-1NE38, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.