Stiebel Eltron FCR 21/60 handleiding
Handleiding
Je bekijkt pagina 19 van 100
www.stiebel-eltron.com FCR 21 | 19
ENGLISH
INSTALLATION
Safety
INSTALLATION
7. Safety
Only a qualified contractor should carry out installation, commis-
sioning, maintenance and repair of the appliance.
7.1 General safety instructions
We guarantee trouble-free functional and operational reliability
only if original accessories and spare parts intended for the ap-
pliance are used.
7.2 Instructions, standards and regulations
Notice
Observe all applicable national and regional regulations
and instructions.
7.3 Water connection and safety assembly
Notice
Carry out all water connection and installation work in
accordance with regulations.
The water inlet and outlet pipes of the cylinder in which the ap-
pliance is installed must be made of metal.
Metal parts of the cylinder that can be touched and that are in
contact with water must be permanently and reliably connected
to the protective conductor.
Notice
A safety valve is required.
The max. permissible pressure must not be exceeded (see chapter
“Specification/ Data table” and cylinder specification).
f Install a type-tested safety valve in the cold water inlet.
Please note that, depending on the supply pressure, you may
also need a pressure reducing valve.
f Size the drain so that water can drain off unimpeded when
the safety valve is fully opened.
f Fit the drain pipe of the safety valve with a constant fall in a
room free from the risk of frost.
f The drain connection of the safety valve must remain open to
the atmosphere.
8. Appliance description
8.1 Standard delivery
The following are delivered with the appliance:
- Plastic cap for the rapid heat-up button
- Jumpers
D0000119253
8.2 Accessories
Required accessories
Safety assemblies and pressure reducing valves are available
to suit the prevailing supply pressure. These type-tested safety
assemblies protect the appliance against impermissible excess
pressure.
9. Installation
Notice
To prevent excessively high control panel temperatures,
the control panel must not be thermally insulated.
The condensate drain aperture in the control panel must
remain open while the cylinder is thermally insulated so
that any condensate that occurs can drip off freely.
f Observe the required torque values during installation (see
chapter “Specification/ Data table”).
f Always install the appliance as set out in the specification
with the cable entries facing downwards.
f Always install the appliance with heating elements and a
protective pipe arranged in parallel. For this, use the screws
supplied. Realign the components where necessary.
9.1 Electrical connection
WARNING Electrocution
Carry out all electrical connection and installation work
in accordance with relevant regulations.
WARNING Electrocution
The connection to the power supply is only permissible
as a permanent connection with a permanently installed
electric cable in conjunction with the removable cable
grommet. Ensure the appliance can be separated from
the power supply by an isolator that disconnects all poles
with at least 3mm contact separation.
Property damage
Install a residual current device (RCD).
WARNING Electrocution
Ensure that the appliance is connected to the earth con-
ductor.
Bekijk gratis de handleiding van Stiebel Eltron FCR 21/60, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Stiebel Eltron |
| Model | FCR 21/60 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 16693 MB |
