Standard Horizon HX40 handleiding
Handleiding
Je bekijkt pagina 36 van 52
Page 34
10. ATIS SETUP
(
HX40E only
)
The HX40E supports the ATIS
(
Automatic Transmitter Identication System
)
used in Inland waterways in Europe. When enabled ATIS mode transmits a
unique ATIS code each time the PTT switch is released at the end of a trans-
mission.
Users should check with their local marine regulatory authority in their country
for assistance in obtaining an ATIS code.
WARNING
The ATIS code can be inputted only once, please be careful not to
input the incorrect ATIS code. If you need to change the ATIS code after
it has been entered, the radio will have to be returned to Factory Service.
Refer to the section “11.2 FACTORY SERVICE”.
10.1 ATIS CODE PROGRAMMING
1.
Press and hold
[
ENT/MENU
]
“
ATIS SETUP
”
“
ATIS CODE
”
2.
Press the
[▲] or [▼]
key to select the rst
number of your ATIS, then press the
[
ENT/
MENU
]
key to step to the next number.
3. Repeat step 2 to set your ATIS
(
ten digits
)
.
4. If a mistake was made entering in the ATIS, press the [◄] or [►] key to
select the [DEL] soft key, then press the [ENT/MENU] key to delete the
wrong number then perform step 2.
5. After the ten numbers have been entered, “FINISH” is selected. Press
the [ENT/MENU] key.
6. The Radio will ask you to input the ATIS number again. Perform steps 2
through 5 above.
7. After the second number has been input, press the
[
ENT/MENU]
]
key to
store the ATIS number in memory.
8. Press the
[
ENT/MENU
]
key to return to radio operation.
Bekijk gratis de handleiding van Standard Horizon HX40, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Standard Horizon |
| Model | HX40 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 5154 MB |
