Stamos PROLOX 65VO handleiding
Handleiding
Je bekijkt pagina 19 van 167
EN
j) Make sure the grounding cable is properly connected and that the plug is properly inserted
into the grounded outlet. Improper grounding of the unit may result in a risk to life or health.
k) Regularly check the power cables for damage or lack of insulation. A damaged cable should
be replaced. Careless repair of insulation may result in death or personal injury.
l) Turn off the device when not in use.
m) The cable must not be wrapped around the body.
n) The workpiece must be properly grounded.
o) Only accessories that are in good condition may be used.
p) Damaged parts of the device must be repaired or replaced. Use safety belts when working at
heights.
q) All equipment and safety items should be stored in one place.
r) Keep the tip of the handle away from the body when the trigger is activated.
s) Attach the ground cable to the workpiece or as close to it as possible (e.g. to the workbench).
t) The work clamp must be insulated if not connected to the workpiece, to avoid contact with
metal.
u) The product is designed for indoor use. However, if it has been exposed to dampness or rain,
a check must be made to ensure that water droplets do not get inside, which could result in
an accident.
v) Do not allow the unit to get wet.
Caution! The machine may still be live when the power cord is disconnected.
w) After turning off the unit and disconnecting the voltage cable, check the voltage on the input
capacitor and make sure that the voltage value is zero, otherwise do not touch the unit
components.
ATTENTION Although the appliance has been designed to be safe, with adequate safeguards,
and despite the use of additional safety features for the user, there is still a slight risk of accident or
injury when handling the appliance. It is advisable to exercise caution and common sense when using
it.
4.6. Gases and fumes
Caution! Gas can be hazardous to health or lead to death!
a) Always keep a distance from the gas outlet.
b) When cutting, pay attention to the exchange of air, avoiding gas inhalation.
c) Remove chemical substances (greases, solvents) from the surface of the workpieces as they
burn under high temperature, giving off poisonous fumes.
d) Cutting galvanized parts is allowed only with efficient extraction with filtration and a supply
of clean air. Zinc vapours are very toxic, and the symptom of poisoning is the so-called zinc
fever.
5. Instructions for use
5.1. General
a) The device should be used in accordance with its intended purpose, in compliance with the
health and safety regulations and the restrictions resulting from the data on the rating plate
(IP level, duty cycle, supply voltage, etc.).
b) Do not open the unit as this will void the warranty; also, exploding exposed parts may cause
injury.
c) The manufacturer shall not be liable for technical changes of the equipment or material
damage resulting from the introduction of these changes.
d) If the equipment malfunctions, contact the service centre.
Bekijk gratis de handleiding van Stamos PROLOX 65VO, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Stamos |
| Model | PROLOX 65VO |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 29510 MB |
