Stamos PROLOX 65VO handleiding
Handleiding
Je bekijkt pagina 18 van 167
EN
i) Use the appliance at an ambient temperature between -10 and 40 °C, in a room with low
humidity and dust, without direct sunlight.
j) If cutting takes place in a location where there are rapid air movements, use a wind shield.
k) Assume a stable position before cutting.
l) Do not use a plasma torch to heat up frozen pipes.
m) Do not plasma cut near flammable materials/tanks. Flammable materials or tanks must be
removed or thoroughly emptied.
n) Do not plasma cut in an atmosphere containing combustible particles or vapours of explosive
substances.
o) Plasma cutting must not be used on pressurised tanks, pressure piping or pressure
accumulators.
p) Plasma cutting station must be positioned away from flammable surfaces.
q) Get rid of flammable or explosive objects such as propane butane lighters or matches before
plasma cutting.
r) Observe health and safety regulations for welding work and equip the work area with a
suitable fire extinguisher. The flame and the working circuit are live as long as the electrical
supply is switched on. The input circuit and the internal circuit of the unit are also live as long
as the electrical supply is switched on.
Caution: cutting in the vicinity of tanks or drums with flammable substances is prohibited.
Remember! Protect children and other bystanders when working with the device.
4.4. Personal protective equipment
Caution! Arc radiation can damage the eyes or skin of the body.
a) When cutting, wear clean, oil-free protective clothing made of non-flammable and non-
conductive material (leather, thick cotton), leather gloves, high boots and a protective hood.
b) Before cutting, get rid of any flammable or explosive items such as propane-butane lighters
and matches.
c) Use face protection (helmet or shield) and cover the eyes with a shade matching the welder's
eyesight and cutting current. The safety standards suggest a No. 13 tint for any amperage
below 300 A. Lower shield tints may be used if the arc is covered by the workpiece.
d) Always use approved safety glasses with a side shield under the helmet or other shield.
e) Use workplace shields to protect others from glare or spatter.
f) Always wear earplugs or other hearing protection against excessive noise and to prevent
spatter from entering your ears.
g) Bystanders should be warned against looking at electric arc.
h) The electric arc in the cutting process produces large amounts of visible and invisible
radiation (ultraviolet and infrared radiation), which can damage the eyes and skin.
4.5. Protection against shock
Caution! Electric shock can be fatal.
a) Plug the power cord into the nearest outlet and route it in a practical and safe way. Avoid
spreading the cable carelessly around the room on an unstudied surface, which may result in
electric shock or fire.
b) Contact with electrically charged parts can cause an electric shock or severe burns.
c) The electric arc and the working area are electrically charged when the current flows.
d) The input circuit and the internal circuitry of the unit are also live when the power is on.
e) Do not touch the live components.
f) Wear dry, lint-free, insulated gloves and protective clothing.
g) Use insulating mats or other insulating coatings on the floor that are large enough to prevent
contact between the body and the object or the floor.
h) Do not touch the electric arc.
i) Turn off the power supply before handling, cleaning or replacing the electrode.
Bekijk gratis de handleiding van Stamos PROLOX 65VO, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Stamos |
| Model | PROLOX 65VO |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 29510 MB |
