Stamos PROLOX 65VO handleiding
Handleiding
Je bekijkt pagina 17 van 167
EN
h) Do not use the product with the housing removed.
i) Dispose of all welding waste in accordance with local regulations.
4.2. Guidelines for securing fire hazardous work
Preparing the building and rooms for fire hazardous works consists in:
a) cleaning the rooms or places where the work will be carried out of any flammable materials and
contamination;
b) move all flammable and non-flammable objects in flammable packaging to a safe distance;
c) protect materials which cannot be removed by covering them, for example, with metal sheets,
gypsum boards, etc. against the effects of plasma cutting splatter;
d) checking whether materials or objects susceptible to ignition in adjacent rooms do not require
local protection;
e) seal with non-flammable materials any through-holes in installation, ventilation, etc., located in
the vicinity of the place of work;
f) protect against plasma cutting splatter or mechanical damage all electric, gas and installation
cables with flammable insulation, provided that they are within the range of risk caused by fire
hazardous works;
g) check whether any painting or other works using flammable substances were not carried out on
that day.
Sparks may cause fires
Cutting sparks can cause fires, explosions and burns to unprotected skin. Wear welding gloves and
protective clothing when cutting. Remove or secure all flammable materials and substances from the
work area. Do not cut closed containers or tanks that have contained flammable liquids. Such
containers or tanks should be flushed before cutting to remove flammable liquids. Do not cut near
flammable gases, vapours or liquids. Fire fighting equipment (fire blankets and powder or snow
extinguishers) should be located near the work area in a visible and easily accessible location.
Cylinders can explode
Use only approved gas cylinders and a properly functioning regulator. Cylinders should be transported,
stored and positioned upright. Protect cylinders from heat, tipping and mechanical damage. Keep all
parts of gas installation in good condition: cylinder, hose, fittings, regulator.
A cut can cause a fire or an explosion.
The plasma jet throws glowing metal particles or sparks outwards. Hot metal particles, sparks, a heated
component or a hot torch can cause a fire. For this reason, the surroundings of the work area should
be carefully checked for safety.
4.3. Preparation of the workplace for cutting
a) All combustible materials should be removed within a radius of 12 m from the burner.
b) If this is not possible, combustible materials must be covered with a suitable coating.
c) Cutting in areas where ignition of flammable materials may occur is prohibited.
d) Take precautions against sparks and glowing metal particles.
e) Care must be taken that sparks or hot metal splinters may pass through cracks or openings.
f) Pay close attention to arcing and have a fire extinguisher within close reach.
g) Be aware that cutting near the ceiling, on the floor or between compartments can cause a
flame fire on the other side which is not visible.
h) Always ensure sufficient ventilation.
Bekijk gratis de handleiding van Stamos PROLOX 65VO, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Stamos |
| Model | PROLOX 65VO |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 29510 MB |
