SRS DC215 handleiding

Handleiding

123456789101112131415161718192021222324252627282930313233343536373839404142434445464748495051525354555657585960616263646566676869707172737475767778798081828384858687888990919293949596979899100101102103104105106107108109110111112113114115116117118119120121122123124125126127128129130131132133134135136137138139140141142143144145146147148149150151152153154155156157158159160161162163164165166167168169170171172173174175176177178179180181182183184185186187188189190191192193194195196/ 196

Afdrukken

Je bekijkt pagina 28 van 196

Manual Conventions and Organization vi

Stanford Research Systems DC215 Voltage/Current Source

Example 5: Ramping

This section describes how to configure and control ramps.

Note: The DC215 and DMM should set to the configuration at the end of Example 4.

1) Turn the output on.

2) Press the [↓] SETTING key four times until T

ramp

is displayed. Type [2] [0]

[Enter] to set the ramp time to 20 s.

3) Press the [↑] SETTING key four times until Source is displayed.

4) Set the output to +10.0 V.

5) Press the [↓] SETTING key to display RealTime. Watch as the RealTime, voltage

monitor and DMM all ramp up to 10 V.

6) Press the [↑] SETTING key to display Source.

7) Set the output to 0 V.

8) Press [SHIFT] [PAUSE] to pause the ramp. Change the SETTING display to

RealTime. Note that the Pause Indicator is blinking and RealTime, voltage

monitor and DMM are all the same voltage.

9) Press [SHIFT] [PAUSE] again to resume the ramp. Note that the Pause Indicator

has stopped blinking and RealTime, voltage monitor and DMM are all ramping

again.

10) Press [SHIFT] [PAUSE] a third time to again pause the ramp. Note the values for

RealTime, VMon and the DMM.

11) Press [SHIFT] [Enter]. This terminates the ramp and sets the output to the ramp

value when [SHIFT] [Enter] was pressed. Confirm the values for RealTime,

VMon and the DMM.

12) Press the [↑] SETTING key to display Source. Set the output to 0 V.

13) After a few seconds, press [SHIFT] [STEP]. This immediately terminates the

ramp at the final set value. Confirm the values for RealTime, voltage monitor

and the DMM.

14) Set the output to 10V.

15) After a few seconds, press [SHIFT] [CLR]. This immediately terminates the ramp

to the previous set value. Confirm the values for RealTime, VMon and the

DMM.

16) Turn the output off.

123456789101112131415161718192021222324252627282930313233343536373839404142434445464748495051525354555657585960616263646566676869707172737475767778798081828384858687888990919293949596979899100101102103104105106107108109110111112113114115116117118119120121122123124125126127128129130131132133134135136137138139140141142143144145146147148149150151152153154155156157158159160161162163164165166167168169170171172173174175176177178179180181182183184185186187188189190191192193194195196/ 196

Bekijk gratis de handleiding van SRS DC215, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

Andere merken in Niet gecategoriseerd