Speed Queen FV6010WN handleiding
Handleiding
Je bekijkt pagina 85 van 119
Programming the Hold Step Type
The Hold Step Type allows the owner to pause a cycle at a specif-
ic type to allow user interaction with the cycle, generally to add a
chemical. After selecting the desired Cycle Step number and
pressing START (enter), XXHoLd will appear in the display.
Press the DELICATE (∧) or the HOT (∨) keypad to scroll
through the options and START (enter) to select a value.
Step
Type
Display
A Display B Values Description
XXHoLd Hold Step Type (XX is step number, step type is
flashing)
En diS XXHo01 EnAbLE, diSAbL, dNod
1, dNod 2
Step Enable/Disable
Choosing dNod 1 and dNod 2 will enable the step
if the cycle modifier is chosen and set to be enabled
in Cycle Modifier Programming CNP- .
StAtUS XXHo02 PrEWSH, WASH, rinSE1,
rinSE2, rinSE3,
rinSE4, SPin
Status LED: The corresponding LED on the control
will be lit during this step.
NinUtE XXHo03
0-2 Step Minutes: If Programmed Cycle Time Display is
enabled and set to a value greater than zero, it will
override this time.
SECond XXHo04
0-59 Step Seconds: If Programmed Cycle Time Display is
enabled and set to a value greater than zero, it will
override this time.
AUdioP XXHo05
0-20 Audio Pattern: The audio will stop once a key is
pressed or the door is opened.
NESSAg XXHo06 LoAd, CHEN, SoAP,
bLEACH, SoFtnr, SoUr,
StArCH, CUStN1, CUStN2
Display Message
StArtP XXHo07 StrtCy, UnLoCk
Door Lock State
AUrESN XXHo08
0-255 Automatic Resume Minutes: Cycle will resume au-
tomatically after the programmed time only if the
step was programmed to have the door remain
locked.
oUtP 1 XXHo12 oFF, on
External Output #1
oUtP 2 XXHo13 oFF, on
External Output #2
oUtP 3 XXHo14 oFF, on
External Output #3
oUtP 4 XXHo15 oFF, on
External Output #4
Table 22
While in the Hold Step, a message is used to indicate what inter-
action the machine is waiting for. The Hold step can be program-
med to either hold water and keep the door locked or to evacuate
water and unlock the door. In both cases a Start key press will al-
low the cycle to resume.
This step may be used to allow the machine to be rinsed out be-
fore adding the next load. An additional vend could be charged
by having a Modifier Key programmed to enable steps to perform
this functionality by setting the steps as Mod 1 or Mod 2. Refer to
Cycle Modifier Programming CNP- .
Programming Control
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
85 Part No. 807870ENR4
Bekijk gratis de handleiding van Speed Queen FV6010WN, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Speed Queen |
| Model | FV6010WN |
| Categorie | Wasmachine |
| Taal | Nederlands |
| Grootte | 14039 MB |
