Speed Queen FV6010WN handleiding
Handleiding
Je bekijkt pagina 111 van 119
Error Codes
Display Description Cause/Corrective Action
E Sd
Slow Drain Error If a slow drain is detected in the Drain step of a running cycle, the machine control
will light the right-most decimal point. The decimal point will remain illuminated af-
ter the slow drain error display has expired, to draw the attention of the owner or at-
tendant. The decimal point can be cleared by pressing the START keypad 3 times in a
period of 5 seconds, or by cycling the power to the machine.
E SudS
Suds Lock Error In the spin steps, if the control determines that there are suds in the machine after run-
ning all programmed Suds Routines, it will display a Suds Lock Error at the end of the
cycle after the door is opened. The control will continue showing this error code until
any key has been pressed or for one minute.
E Ld
Water Leak Drain
Error
Error will display if there is a leak after the door is opened at the End of Cycle for 1
minute. Clears after 1 minute or until a key is pressed. If the water level has dropped
more than an acceptable amount in a during a water leak drain check, the control will
save a water leak drain error status and will continue the machine cycle. Immediately
upon detecting the error the right-most decimal point will be lit. This lit decimal point
can be cleared by pressing the START keypad 3 times in a period of 5 seconds or by
cycling the power to the machine.
E nFLo
No Water Flow Er-
ror
If the control does not reach a water level of 4 inches within the programmed time it
may mean the hose to the pressure sensor has a leak or no water is flowing into the
machine. The control will enter Machine Error mode. The control will first drain for
90 seconds and then turn off all outputs and turn on the Machine Error Tone for 15
seconds. To clear this error one of the following must occur: the machine must be
powered down, the Clear Fatal Error Keys must be pressed, or a Clear Fatal Error Net-
work command must be sent.
E oF
Overflow Error The machine must be powered down, the Clear Fatal Error Keys must be pressed, or a
Clear Fatal Error Network command must be sent. This error is triggered when an un-
safe high water level is detected in the machine and water is unable to drain.
E PS
Pressure Sensor
Error
If the control does not detect a valid water level sensor input for thirty (30) seconds, or
if the Max (Overflow) Fill Level in the control is set to 0 while in Run Mode, Factory
Test Mode, or Overflow Mode, the control will enter Machine Error Mode. The con-
trol will first drain for thirty (30) seconds to get out any water, and unlock the door. To
clear this error one of the following must occur: the machine must be powered down,
the Clear Fatal Error Keys must be pressed, or a Clear Fatal Error Network command
must be sent.
E tr
Trim Error The machine must be powered down, the Clear Fatal Error Keys must be pressed or a
Clear Fatal Error Network command must be send.
E bELt
Broken Belt Error If a broken belt is ever detected by the control, the control will show error this error
code. To clear this error one of the following must occur: the machine must be pow-
ered down, the Clear Fatal Error Keys must be pressed, or a Clear Fatal Error Network
command must be sent.
Table continues...
Error Codes
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
111 Part No. 807870ENR4
Bekijk gratis de handleiding van Speed Queen FV6010WN, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Speed Queen |
| Model | FV6010WN |
| Categorie | Wasmachine |
| Taal | Nederlands |
| Grootte | 14039 MB |
