Spear & Jackson S7520EPSP handleiding
Handleiding
Je bekijkt pagina 17 van 25
17 of 25V3.5: 11/23 AFTER SALES SUPPORT 0345 605 2067
OPERATION
60º MAXIMUM
Load
Second Cut
First Cut
1/3 Diameter
Finishing Cut
Hold the machine
Balance your weight with both feet on solid ground. Your
body should always be to the left of the chain line. Grip handle
tightly. The most typical cutting application is to position
the unit at an angle of 60°or less depending on the specic
situation. As the angle of the pole chain saw shaft to the
ground increases, the difculty of making the rst cut (from the
underside of limb) increases.
Start cutting
· Cut lower branches first to allow the top branches more
room to fall.
· When pruning trees, it is important not to make the finishing
cut next to the main limb or trunk until you have cut off the
farthest lying limb. This will reduce the weight and prevent
stripping the bark from the main member.
· Under cut the branch 1/3 through for your first cut. Your
second cut should over cut to drop the branch off.
· Be prepared to balance the weight of the pole chain saw
when the limb falls.
Disconnect power source
When nished working, switch off the machine and disconnect
plug from power source.
3
4
5
Bekijk gratis de handleiding van Spear & Jackson S7520EPSP, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Spear & Jackson |
| Model | S7520EPSP |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2374 MB |
