Sommer ENTRAcode+ handleiding
Handleiding
Je bekijkt pagina 22 van 36
22
8.5 Access Control
NOTE
The security function "Access Control" can
be used in both operating modes.
Here, a radio command is sent to a separate
radio receiver after 3 attempts to enter an
invalid 8-digit PIN code. It can be used, for
example, to activate a camera or an alarm
system.
► During programming of the Access
Control radio command, no radio receiv-
er which, for example, opens a gate or a
door may be in programming mode, as
the Access Control command will then be
programmed to that receiver. This would
mean that the gate / the door opens after
entering 3 invalid 8-digit PIN codes.
► Make sure that only the separate radio
receiver intended for the Access Control
function is in programming mode when the
Access Control command is transmitted.
► On the battery-operated version
ENTRAcode+ AP, rst press the # key to
wake the device from power-saving mode.
► Can be used in both operating modes.
som4.me/man
8. Operation / Operation for both operating modes
8.4 Changing the operating mode
#
R
► Enter the key combination above in the order shown.
⇒ The green and red LED light up for 2 seconds
⇒ During this time, the backlighting goes out
✔ Operating mode has been successfully changed
Bekijk gratis de handleiding van Sommer ENTRAcode+, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Sommer |
| Model | ENTRAcode+ |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3875 MB |
