Singer Ditto handleiding
Handleiding
Je bekijkt pagina 7 van 26
7
1 in.
Note! Face the flat side of the beam towards the
work area.
14. Position the beam vertically between the floor and
the ceiling and release the beam.
15. Adjust the beam by pressing down, repositioning
and releasing until the bubble in the bubble level is
centered.
Warning! After assembly, ensure that beam
is secured to both floor and ceiling. Carefully pull
the beam by hand to make sure that the beam still
stands steady between the floor and the ceiling. If
not secure in place, there is a risk of the beam falling
over and injuring people or causing damage to
furniture or floors, etc.
To Attach the Projector
1. Slide the projector carrier to eye level.
2. Attach the projector to the projector carrier with the
lens facing the ceiling.
3. Turn the projector 180 degrees counterclockwise
until it clicks into place, facing downward.
Click!
To Assemble the Cutting Mat
1. Unfold the cutting mat.
2. Put the cutting mat on the work area with the Ditto
logo facing away from the beam.
Caution! The cutting mat must lay completely
flat and fully on the work surface. Draping the
mat off the edge of a surface will result in poor or
incomplete calibration causing inaccurate pattern
piece projection.
Bekijk gratis de handleiding van Singer Ditto, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Singer |
| Model | Ditto |
| Categorie | Naaimachine |
| Taal | Nederlands |
| Grootte | 2624 MB |
