Simrad Recon UI Board handleiding
Handleiding
Je bekijkt pagina 7 van 8
7
Update software
Wait for software versions to match
When the trolling motor is powered on after any new board
is installed, the GPS/PCB assembly in the head of the
trolling motor automatically pushes its current software
to the mount controller board (even if the mount controller
board has been loaded with a more recent version of the
software).
Wait for this to complete before pushing the latest available
software to the trolling motor.
Update the trolling motor to the latest available
software
After installing any new circuit board, you should install the
latest available software on the trolling motor.
For instructions on how to update the trolling motor
software, refer to the Recon™ operator manual.
Before updating:
• Stow the trolling motor.
• Pair and connect any foot pedals and remote controls
you want to use, so they receive the same software
update.
When updates are complete, power cycle the trolling motor
then wait 60 seconds before starting calibrations.
Calibration
After you’ve replaced the mount controller board and
updated the software, you need to re-calibrate the trolling
motor’s centerline, bow offset, and compass, and power
cycle the trolling motor.
Calibrate the centerline
¼ Note: Calibrating the trolling motor’s centerline is
currently achieved using an Advanced Wireless Foot
Pedal. It will be supported in future releases of the
FreeSteer™ Joystick Remote and the Lowrance and
Simrad
®
mobile apps.
Foot pedal
1 Deploy the trolling motor to where the lower unit can be
seen and is able to rotate 360° without obstruction. For
best visibility, slide the cam lock depth collar down so
the lower unit is close to the mount.
¼ Note: The motor does not need to be in the water for this
calibration—it just needs to be deployed and free of any
obstructions when rotating the lower unit.
2 Power on the trolling motor and make sure it is
connected to the Advanced Wireless Foot Pedal.
3 To enter service mode, press and hold the and keys
on the foot pedal simultaneously until the trolling motor
beeps twice and the LEDs on the mount start flashing.
4 To enter centerline calibration mode, press and hold the
and keys on the foot pedal simultaneously until the
trolling motor beeps twice.
5 By hand, move the lower unit nosecone (A) until it is
parallel to the center of the steering transmission (B),
then press and hold the key on the foot pedal until the
motor beeps twice.
B
A
Bekijk gratis de handleiding van Simrad Recon UI Board, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Simrad |
| Model | Recon UI Board |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 1959 MB |
