Simrad Recon UI Board handleiding
Handleiding
Je bekijkt pagina 6 van 8
6
Install mount UI cover
To attach the LED assembly to inside of the mount UI cover:
1 Make sure the ribbon cable (A) from the mount circuit
board is not twisted. Position the LED assembly (B) on
the inside of the mount UI cover by aligning the screw
holes.
2 Use a T15 Torx
®
bit or screwdriver to install two #6x3/8
pan head screws (C, supplied. These 3/8 inch-length
screws are the shorter T15 Torx
®
screws supplied in the
service kit). Tighten to torque 0.68 Nm (6 in-lb).
C C
B
A
To t the mount UI cover:
3 Inside the mount, use the supplied cable ties in the three
positions shown below (A) so that cables aren’t strained
or pinched when you install the UI cover.
Pass one cable tie through two holes on the port (left)
side of the mount, and around the transmission cable
molded connector. Pull the cable tie tight to prevent
movement, and trim excess length.
Pass another through two holes on the starboard (right)
side of the mount, and around the communication cable
molded connector. Pull the cable tie tight to prevent
movement, and trim excess length.
Use the third cable tie to loosely hold the
communication cable to itself, and trim excess length.
4 Inside the mount, check the grommet on the
transmission cable (D) is tted into the cable retainer (E).
E
A
D
5 Lower the mount UI cover into position. Guide its front
face to t over the cable retainer and grommet.
6 Ease the coil cable bracket (F) into position so that the
root of the coil cable is gripped between the mount UI
cover and the coil cable bracket. Use a 5/32 in Allen key
to tighten the two screws (G) that secure the coil cable
bracket. Tighten to torque 5.08 Nm (45 in-lb).
7 Use a 2 mm Allen key to install two M3-0.5 x 8, flange
screws (H, supplied) from both sides of the UI cover.
Tighten to torque 0.35 Nm (3 in-lb).
H
G
F
To replace the side plates on the mount:
8 Insert the front locating tab (I) of the port side plate into
its locating slot on the port side of the mount.
9 Gently apply pressure below the other locating tab (J)
and flex it into its locating slot.
10 Guide the strain relief (K) around the base of the coil
cable.
J
I
K
11 Fasten the side plate screws and tighten to torque
1.69Nm (15 in‑lb).
12 To replace starboard side plate on mount, insert the
locating tabs into their locating slots and gently attach
the plate.
13 Fasten the side plate screws and tighten to torque
1.69Nm (15 in‑lb).
Bekijk gratis de handleiding van Simrad Recon UI Board, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Simrad |
| Model | Recon UI Board |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 1959 MB |
