Simrad Recon UI Board handleiding

8 pagina's
PDF beschikbaar

Handleiding

Je bekijkt pagina 3 van 8
3
3 Use 2 mm Allen key to remove the two screws (C) that
attach the stow sensor to the outside of the mount.
4 Carefully feed the sensor and its cable through the hole
(D) above the linkage, so the stow sensor is on the inside
of the mount.
¼ Note: The stow sensor cable remains attached to the
mount controller board.
C
D
Remove mount controller board
1 Use a 3 mm Allen key to remove the four socket head
screws (A) holding the mount controller board in the
base of the mount.
¼ Note: Various connectors and the stow sensor remain
attached to the mount controller board. Cables and
connectors are not shown in the diagram below.
A
A
A
A
2 Make sure all connectors are disconnected and wires
are free from the mount, and gently lift the mount
controller board out of the mount.
Installation
To install the new mount controller board:
1 Orientate the board with the attchment point for the
LED board ribbon cable (A) to the front. Fit the mount
controller board into the base of the mount.
¼ Note: Cables and connectors are not shown in the
diagram below.
2 Use a 3 mm Allen key to install four M4-0.7 x 18 socket
screws (supplied) in the corners of the board (B).
Tighten to torque 2.03 Nm (18 in-lb).
B
B
B
B
A
C
Replace lower routing bracket
¼ Note: Replacing the lower routing bracket is only
necessary if you have stripped the routing brackets’
screw bosses.
1 Use a 3 mm Allen key to remove the two M4‑0.7x18
socket screws (C, above). Lift the lower routing bracket
out vertically, and replace with the new lower routing
bracket (supplied).
2 Use a 3 mm Allen key to install two M4-0.7 x 18 socket
screws (supplied). Tighten to torque 2.03 Nm (18in‑lb).

Bekijk gratis de handleiding van Simrad Recon UI Board, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

MerkSimrad
ModelRecon UI Board
CategorieNiet gecategoriseerd
TaalNederlands
Grootte1959 MB