Simrad Recon UI Board handleiding
Handleiding
Je bekijkt pagina 2 van 8
2
7 Lift the UI cover upward to separate it from the mount.
⚠ WARNING: Do not lift the UI cover more than 30 cm
(~12 in) above the mount, to avoid damaging the ribbon
cable (F) that remains connected to the mount.
F
8 Rest the UI cover beside the mount, open side upward.
9 Use a T15 Torx
®
screwdriver to remove the two screws
(G) that secure the LED assembly (H) to the inside of the
UI cover.
¼ Note: The ribbon cable (F) remains attached to the LED
assembly and to the mount controller board.
G G
H
F
Disconnect cables
1 Inside the trolling motor mount, cut the three cable ties.
2 Disconnect the connectors on the transmission and
communication cables (A and B) by rotating the
connectors a quarter turn counter-clockwise.
3 Use a 5/32 in Allen key to remove the screws and cables
from the attachment points C, D, and E.
¼ Note: Two cables attach at C. The screws used to secure
the ring connectors in positions C, D, E have a yellow
thread-locking compound applied to them.
C
D
E
A
B
G
H
F
A Connector, transmission cable
B Connector, communication cable
C Attachment point for ground cables from coil cable
and trolling motor power supply
D Attachment point for trolling motor power supply
(positive)
E Attachment point for coil cable power supply
(positive)
F Screws, upper routing bracket
G NMEA 2000
®
cable (connector is outside the mount)
H Sonar cable (connector is outside the mount)
4 Use a T15 Torx
®
screwdriver to remove the two screws
securing the upper routing bracket (F above), and lift off
the upper routing bracket.
5 Outside the mount, disconnect the NMEA 2000
®
cable
(G, above) from the boat’s NMEA 2000
®
network. You
may also disconnect the sonar cable (H, above) from the
boat if this gives you more room.
Detatch stow sensor
To detatch the stow sensor:
1 Use a 2 mm Allen key to remove the screw (A) that
attaches the stow sensor magnet holder to the
starboard (right) linkage on the outside of the mount.
2 Remove the magnet holder (B), and set it down
somewhere safe.
⚠ WARNING: The magnet holder contains a strong
permanent magnet.
A
B
Bekijk gratis de handleiding van Simrad Recon UI Board, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Simrad |
| Model | Recon UI Board |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 1959 MB |
