Simrad Active Imaging HD (Thru-Hull) Handleiding (32 Pagina's)

Handleiding

23

Attach transducer to fairing block

1 Outside the hull, ip over the bottom half of the fairing block so that the transducer pocket (A) is

upward. Feed the transducer cable though the large hole (B).

B

A

2 Generously coat the transducer pocket in the bottom half of the fairing block with a marine sealant

suitable for below-waterline use, such as Sikaex

®

291 or 3M™ 4200.

Apply enough sealant so that when the transducer and fairing block are mated, the sealant pushes out

to ll the gap between the edge of the transducer and the fairing block pocket.

Insert the transducer into the bottom half of the fairing block so the at faces meet.

3 Wipe away excess sealant that oozes onto the urethane surface of the transducer or the fairing block.

4 Carefully remove the masking tape from the transducer before the sealant dries.

Bekijk gratis de handleiding van Simrad Active Imaging HD (Thru-Hull), stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.