Simrad Active Imaging HD (Thru-Hull) handleiding

Niet gecategoriseerd

Simrad

32 pagina's

PDF beschikbaar

Handleiding

5 Position the cut face of the upper part of the fairing block (E) against the outer hull of the boat (F),

matching the large hole in the fairing block to the hole you just made in the hull. Make sure the fairing

block is parallel to the boat’s keel.

6 Mark the position on the outside of the hull for the anti-rotation stud hole. This hole is astern of

(behind) the rst hole you made. Create a pilot hole (diameter 3 mm (

1/8 in) for the anti-rotation stud

hole.

7 Use a 19 mm (

¾ in) hole saw. Use the top part of the fairing block upside down (E) to guide the hole saw

into the pilot hole, making sure the drill is perpendicular to the waterline.

¼ Note: Do not use the bottom part of the fairing block as a drill guide.

8 Drill a 19 mm (

¾ in) hole through the hull from outside to inside.

D Drill perpendicular to the waterline

E Top half of fairing block (upside down)

F Hull (not to scale)

9 Deburr all holes after drilling.

Fit anti-rotation stud

The anti-rotation stud prevents the transducer and fairing block from rotating relative to the hull when the

boat moves through the water.

¼ Note: Always install an Active Imaging HD (Thru-Hull) transducer with its anti-rotation stud.

1 Thread two M10 nuts (supplied) onto the end of the anti-rotation stud that does not have the blue

nylon threadlock patch.

2 Tighten the upper nut against the lower nut, so the upper nut acts as a jam nut.

3 Insert the end of the anti-rotation stud with the nylon threadlock patch into the threaded hole on the

transducer.

4 Using a 17 mm wrench on the jam nut (upper nut), tighten the anti-rotation stud securely into the

transducer.

5 Remove both M10 nuts from the anti-rotation stud and save them. (Use two wrenches so the threaded

stud is not loosened from transducer while removing the nuts.)

Dry t and mask

Before applying any adhesive sealant, make sure everything ts together.

1 Insert the transducer into the bottom part of the fairing block, with the transducer stem and anti-

rotation stud in the fairing block holes.

2 Put masking tape on the transducer’s urethane surface just outside the rim of the fairing block, to

protect the transducer windows from drips or smears of sealant.

3 Fit this assembly into the prepared holes in the hull.

Bekijk gratis de handleiding van Simrad Active Imaging HD (Thru-Hull), stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.