Simrad Active Imaging HD (Thru-Hull) handleiding

Niet gecategoriseerd

Simrad

32 pagina's

PDF beschikbaar

Handleiding

INSTALLATION

Drill holes in hull

Inside the hull

1 Inside the boat, place the top half of the cut fairing block in its intended position.

The larger hole in the fairing block, for the transducer stem, is at the front (bow) end.

The fairing block should be parallel to the keel, as best you can judge from the inside of the hull.

2 Mark the center of the transducer stem hole on the inside of the hull, and drill a pilot hole for the

transducer stem hole through the hull. (Diameter 3 mm (

1/8 in) is appropriate.)

¼ Note: Check from outside the hull that the pilot hole is in the correct location. If it is not, repeat steps 1 and 2 to

create a new pilot hole. An incorrect hole can be lled with marine sealant.

3 Return to the inside of the boat with a 38 mm (1

½ in) hole saw.

Place the top half of the fairing block in position and use it to guide the hole saw into the pilot hole,

making sure the hole is perpendicular to the waterline (A).

Drill a 38 mm (1½ in) hole through the hull from inside to outside.

A Drill perpendicular to the waterline

B Hull (not to scale)

C Top part of fairing block

Outside the hull

4 Move to outside the boat. Select the top half of the cut fairing block, and turn it over so it is upside

down.

Bekijk gratis de handleiding van Simrad Active Imaging HD (Thru-Hull), stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.