Simrad Active Imaging HD (Thru-Hull) handleiding

Niet gecategoriseerd

Simrad

32 pagina's

PDF beschikbaar

Handleiding

Angle cut for port side installaon

1 Adjust the angle (D) of the saw table to match the deadrise at the mounting location.

2 Note the arrow (E) showing the bow end of the fairing block. Align the fairing block so it enters the saw

blade stern end rst.

¼ Note: Cutting the second fairing block stern end rst lets you keep the saw table at the same angle for the cuts

in both fairing blocks, if the port and starboard hull deadrises are the same.

3 Push the fairing block through the saw blade. Make sure the blade (C) only cuts the fairing block on the

wider side (timber side) of the 0° deadrise groove (A) around the fairing block.

¼ Note: Support the at faces of the timber against the saw table and saw fence. The at faces of the timber keep

the fairing block aligned for a plane cut.

4 After the fairing block is cut, remove the upper part of the fairing block from the timber (the screws and

timber can now be reused).

5 Remove any melted plastic or rough edges from both pieces of the fairing block. Ensure the cut surfaces

are smooth and free from debris.

Bekijk gratis de handleiding van Simrad Active Imaging HD (Thru-Hull), stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.