Simrad Active Imaging HD (Thru-Hull) handleiding
Handleiding
Je bekijkt pagina 16 van 32
16
Mount fairing block for cutting
You will need to cut the fairing block into two pieces using a band saw or table saw. To guide your cut,
temporarily attach the fairing block upside down to a piece of timber (not supplied).
1 Cut a piece of planed, square-edged timber slightly longer than the fairing block. Standard 2x4 timber
cut to a length of 16 in (~420 mm) works well.
2 Place the fairing block’s widest surface on the widest face of the timber.
3 Align the long edge of the fairing block ush against the long edge of the timber (A). The larger hole in
the fairing block is at the forward (bow) end of the fairing block.
4 Attach the fairing block to the timber through the two holes (B) on the ends of the fairing block, using
the supplied screws (#2 Philips).
~16”
(~420 mm)
~4”
(~100 mm)
A
B
B
Bekijk gratis de handleiding van Simrad Active Imaging HD (Thru-Hull), stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Simrad |
| Model | Active Imaging HD (Thru-Hull) |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3264 MB |
