Simrad Active Imaging HD (Thru-Hull) handleiding
Handleiding
Je bekijkt pagina 15 van 32
15
Measure hull deadrise
The angle of the fairing block cut depends on the deadrise of the hull at the mounting location.
The deadrise is the angle measured upward from a line parallel to the water surface to the outer surface of
the hull (A).
¼ Note: The diagram shows the back of the vessel (stern), and is not to scale.
ED
A
A
X
C
B
A Deadrise. If the deadrise is greater than 25°, stop and seek further advice.
B Hull. If the hull thickness is greater than 2 in (50.8 mm) at the mounting location, stop and seek further
advice.
C Horizontal, parallel to water surface.
D Plumb line. Use a plumbline and protractor to measure X (the angle complementary to the deadrise) if
you don’t have a clinometer. Deadrise = 90°−X.
E Clinometer, or cellphone with clinometer app.
Bekijk gratis de handleiding van Simrad Active Imaging HD (Thru-Hull), stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Simrad |
| Model | Active Imaging HD (Thru-Hull) |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3264 MB |
