Simrad Active Imaging HD (Thru-Hull) handleiding

Niet gecategoriseerd

Simrad

32 pagina's

PDF beschikbaar

Handleiding

Cut fairing block

⚠ WARNING: To avoid damaging the transducer when using the saw, do not t the transducer into

the fairing block until after the fairing block is cut.

⚠ WARNING: Wear appropriate eye protection, ear protection and dust mask when drilling, cutting

or sanding.

Flat cut for a at hull

If you are mounting the transducer at a at (0° deadrise) position on the hull:

1 The saw blade should be at a right angle (90°) to the saw table.

2 Push the fairing block through the saw blade, making sure the blade cuts along the 0° deadrise groove

on the fairing block (A).

¼ Note: For a hull with 0° deadrise, it doesn’t matter whether the fairing block enters the blade bow rst or stern

rst.

¼ Note: Support the at faces of the timber against the saw table and saw fence. The at faces of the timber keep

the fairing block aligned for a plane cut.

3 After the fairing block is cut, unscrew the upper part from the timber.

4 Remove any melted plastic or rough edges from both pieces of the fairing block. Ensure the cut surfaces

are smooth and free from debris.

Bekijk gratis de handleiding van Simrad Active Imaging HD (Thru-Hull), stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.