Simrad Active Imaging HD (Thru-Hull) handleiding

Niet gecategoriseerd

Simrad

32 pagina's

PDF beschikbaar

Handleiding

Planing hull (inboard: sha or pod drive)

Install the transducer in front of the propellers and shafts, and between the two drives.

Stepped hull

Install the transducer on the rst step back from the bow, as close to the prole change (step) as possible.

The transducer should be as central as possible.

Steep deadrise hull: dual transducer installaon

If the hull of your boat has a steep deadrise angle, or structure such as a keel that partially obstructs the left

or right side beams from a single transducer, a dual installation is needed.

In addition to the other guidelines, the dual transducers should be mounted:

• one each side of the keel, parallel to the keel, and equal distances from the keel.

• in line with each other bow–stern, not one further forward than the other.

The bottom of the keel should be lower in the water than the two transducers.

Install the port transducer on the port side (left side) of the vessel and install the starboard transducer on

the starboard side (right side) of the vessel. The port and starboard transducers are not interchangeable.

Bekijk gratis de handleiding van Simrad Active Imaging HD (Thru-Hull), stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.