Simrad Active Imaging HD (Thru-Hull) handleiding

Niet gecategoriseerd

Simrad

32 pagina's

PDF beschikbaar

Handleiding

MOUNTING LOCATION

The installation involves creating holes in the hull of your vessel, so it is important to be certain of the

transducer’s planned position before you make any holes or cuts.

If you are installing an Active Imaging HD (Thru-Hull, Dual) system, the procedure is the same as the Active

Imaging HD (Thru-Hull, Single) system, but carried out for both the port and starboard transducers.

⚠ WARNING: Before drilling any holes, ensure that holes will be drilled in a safe position. Ensure

you do not drill into tanks, reservoirs, hoses, or cables, etc. and that the holes will not weaken the

structure in any way.

⚠ WARNING: Always wear appropriate eyewear, ear protection and dust mask when drilling,

cutting, or sanding.

⚠ WARNING: When installing, keep the transducer in its protective packaging as much as possible.

Do not pull, carry or hold a transducer by the cable.

Hull material

The instructions in this manual are appropriate for installing the Active Imaging HD (Thru-Hull) Single or

Dual transducer systems into a hull made of metal, wood, or solid berglass.

At the mounting location, the hull must:

• Be no thicker than 50.8 mm (2 in)

• Have a deadrise no steeper than 25°.

These limits are imposed by the height of the transducer stem and fairing blocks.

For hulls with a foam core, extra preparation is needed. The installation area should be reinforced to prevent

deformation of the hull which could allow water to enter. Such installations should be completed with the

guidance of a professional installer.

Location guidelines

• In general, thru-hull transducers should be mounted parallel to and as close as possible to the

boat’s keel, to ensure proper boat handling and water ow under the transducer. However, to avoid

disturbing the water in front of a (centered) propeller, you may need to offset the transducer from

center.

• Do not mount a transducer in line with objects or hull features that could cause turbulent water to ow

around the transducer, including strakes, trim tabs, other fairing blocks or instruments, propellers, or

near water intakes or discharge openings.

• Do not mount a transducer where the boat is supported during trailering, launching, hauling or storing.

• Make sure there is nothing around the mounting location that could block or reect a transducer’s

acoustic beams. Mount a transducer away from areas prone to electrical and acoustic noise and

vibration.

• A transducer will not work while it is out of the water. Ensure it is in contact with the water at all boat

speeds.

Select location

The transducer’s mounting location depends on the shape of your hull.

On single-drive vessels, if the propeller is turning clockwise when viewed from behind the vessel, mount the

Bekijk gratis de handleiding van Simrad Active Imaging HD (Thru-Hull), stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.