Silvercrest SLG 350 D2 handleiding
Handleiding
Je bekijkt pagina 9 van 40
■ 6
│
GB
│
CY
Setting up
For the safe and trouble-free operation of the
device, the set-up location must fulfil the follow-
ing requirements:
♦ Place the appliance on a firm, flat and level
surface.
♦ Position the appliance so that there is suffi-
cient space in front of and behind the lami-
nator. The laminating pouch should be able
to be fully inserted into the laminator and
ejected again without any problems.
♦ Do not operate the device in a hot, wet or
extremely damp environment or near flam-
mable materials.
♦ The mains power socket must be easily
accessible, so that the power cable can
be easily disconnected in the event of an
emergency.
Handling and use
Suitable laminating pouches
For hot lamination, you can use pouches with a
width of up to 230 mm and a maximum thick-
ness of 125 µm. Please note that each laminat-
ing pouch may only be used once.
Note
► For hot lamination, use only laminating
pouches that are expressly intended for hot
lamination.
► For cold lamination, use only laminating
pouches that are expressly intended for cold
lamination.
► Take note that the laminating pouches sup-
plied with the laminator are intended exclu-
sively for hot lamination.
Switching levels
Selector switch
position 2
Laminating pouch
thickness
80 MIC > 60–80
125 MIC 85–125
COLD up to 200
Note
► For high-gloss photos, you should choose
the switch setting 125 MIC as well as the
corresponding laminating pouch thickness.
Preparing for hot lamination
1) Insert the plug of the laminator into a mains
power socket.
2) Press the On/Off switch I/O
0 to switch
the appliance on. The red indicator light
power 7 lights up.
3) Set the selector switch
2 to the desired
pouch thickness (80 MIC/125 MIC) (also
refer to the Switching levels section).
The laminator heats up to operating tem-
perature. As soon as the green indicator
lamp ready
6 lights up, the laminator has
reached its operating temperature.
Note
► The glowing green indicator light ready
6
indicates that the operating temperature has
been reached. For a more uniform laminating
result, especially for thinner pouches (below
125 microns), and after adjustment to a
different pouch thickness, we recommend
that you first wait an additional 2–3 minutes
before starting the lamination.
► The green indicator lamp ready
6 may
occasionally turn off and light up again. This
means that the appliance is maintaining the
temperature and is reheating itself. This is
not a malfunction of the appliance!
4) Place the document to be laminated into a
laminating pouch of the appropriate size.
IB_456368_SLG350D2_CY.indb 6IB_456368_SLG350D2_CY.indb 6 20.08.2024 10:42:2920.08.2024 10:42:29
Bekijk gratis de handleiding van Silvercrest SLG 350 D2, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Silvercrest |
| Model | SLG 350 D2 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3984 MB |
