Senseca XPT800 handleiding
Handleiding
Je bekijkt pagina 63 van 124
XPT800 – Sound Level Meter and Spectrum Analyzer
V1.0
Page 63 of 124
9.9 Starting and stopping a measurement with datalogging
The XPT800 sound level meter enables measurements of sound levels with data storage. The measure-
ment mode uses common calculation functions. Through the graphical interface, the choice of measure-
ment and storage mode is made through commands available on the measurement control bar. In the sta-
tus bar, a specific icon indicates the active measurement mode. The measurement mode with logging as-
sumes that the user has set the desired measurement parameters in the LOG menu. The LAeq parameter
is always stored even if the user has not selected any parameters.
Notice!
•
With this function, the measurement is recorded, the data will be stored.
•
When measuring outdoors with high humidity and using the outdoor microphone unit, it is
recommended to use the preamplifier heater, see “10.8 Activating the preamplifier heat-
er” on page 78.
1
In the ICON MENU, press the MEASURE icon to access the
measurement panel or select a pre-configured setup, see
chapter “9.6 Load a custom configuration” on page 59.
2
Tap the right icon of the control bar to perform the meas-
urement with datalogging.
3
Measurement in progress (see the red circle measurement
icon in the upper right corner).
4
Tap the right icon to STOP measurement, data will be auto-
matically stored.
Bekijk gratis de handleiding van Senseca XPT800, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Senseca |
| Model | XPT800 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 27123 MB |
