Senal CS-88 handleiding

Handleiding

123456789101112/ 12

Afdrukken

Je bekijkt pagina 7 van 12

7

Tip: Use the wire guides to keep the audio cable in place on top of the boom pole.

Note: Make sure the extension cable is long enough to reach from your audio recorder to the

microphone at the end of the boom pole.

4. Insert the extension cable’s 3.5 mm male audio connection into the audio input jack of your

audio recorder.

To turn the microphone on, slide the power switch to the ON position. The power LED will glow green

to indicate that the power is on. When battery power is low, the power LED will glow red.

Using the High-Pass Filter

The high-pass filter helps prevent the CS-88 from picking up low-frequency noises that can interfere

with your recording, like the rumble from an air conditioner.

To turn on the high-pass filter, slide the high-pass filter switch so it rests just above the marking. To

turn off the high-pass filter, slide the switch back so it rests under the marking.

Mounting the CS-88 and Turning It On / Using the High-Pass Filter

▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪

OFF

ON

-10dB

+10dB

0

123456789101112/ 12

Bekijk gratis de handleiding van Senal CS-88, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

Andere merken in Niet gecategoriseerd