Sealer Sales FRM-1120C handleiding
Handleiding
Je bekijkt pagina 26 van 63
FRM- 1120C INSTRUCTION MANUAL
21
Sealer Sales | www.sealersales.com | Tel: 818-718-8818 | E-mail: contact@sealersales.com
Figure 26. Ribbon Webbing Guide
3. Insert the printing head/type holder in the printing block. To lock the printing head, press the
handle on the printing head inward and turn clockwise about 90 degrees. When locked, you should
not be able to pull the printing head out of the printing block.
4. If temperature is left on while imprinter is not in use, we suggest turning the ribbon collect wheel
a few turns so that ribbon exposed to the heat of the printing block is moved into the ribbon
collect wheel. This will prevent ribbon breakage.
Imprinter Adjustments
Best results in hot stamp imprinting depends on correct temperature, pressure, and stroke speed. Different
materials may require adjusting any of these, as follows:
1. Temperature Adjustment. Turn the temperature knob to the appropriate temperature for the
material to be printed. Turning the knob clockwise will cause the temperature to rise and turning
the temperature counterclockwise will cause the temperature to lower. Wait approximately 15-20
minutes for imprinter to reach set temperature.
2. Pressure Adjustment. Normal printing pressures vary with the printing material. Pressure
should be kept just high enough to obtain good results. Too much pressure causes excessive wear
on type and silicone rubber pad. If pressure is too high, the ribbon may break and printed materials
may be melted through. If pressure is too low, the printed characters will be illegible.
Bekijk gratis de handleiding van Sealer Sales FRM-1120C, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Sealer Sales |
| Model | FRM-1120C |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 19569 MB |
