Schneider PowerLogic HDPM6000 handleiding

Niet gecategoriseerd

Schneider

47 pagina's

PDF beschikbaar

Handleiding

PowerLogic

HDPM6000 Installation Guide

Safety Precautions

iii

DANGER

HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR ARC FLASH

• Submetering equipment shall not be mounted within 50.8 mm (2 in.) of

any live parts including primary conductors, primary terminals, primary

lugs. This requirement excludes insulated cables.

• Submeters attached to the enclosure shall not contact the panel interior

insulation.

• Mounting provisions shall not be attached to any live part.

• Voltage sensing and power supply connections to the primary voltage

shall have overcurrent protection.

• Do not install submetering equipment in any area where breaker arc

venting exhaust gasses could be re-directed as a result of submetering

equipment installation.

• This product must be installed inside a suitable re and electrical

enclosure.

• Follow safe electrical work practices. See NFPA 70E in the USA, or

applicable local codes.

• This equipment must only be installed and serviced by qualied electrical

personnel.

• Do not use this device for critical control or protection applications where

human or equipment safety relies on the operation of the control circuit.

• Do not install this product in hazardous or classied locations.

• Read, understand and follow the instructions before installing this

product.

• Turn o󰀨 all power supplying equipment before working on or inside the

equipment.

• Product may use multiple voltage/power sources. Disconnect all sources

before servicing.

• Use a properly rated voltage sensing device to conrm that power is o󰀨.

• Do not use data from this device to conrm power is o󰀨.

• Replace all doors, covers and protective devices before powering the

equipment.

• Do not exceed the product's ratings or maximum limits.

• Treat communications and I/O wiring connected to multiple devices as

hazardous live until determined otherwise.

Failure to follow these instructions will result in death or serious

injury.

If this product is used in a manner not specied by the manufacturer, the

protection provided by the product may be impaired.

The installer is responsible for conformance to all applicable codes.

The safety of any system incorporating this equipment is the responsibility

of the assembler of the system.

Note: See IEC 60950-1:2005, Annex W for more information on

communications and I/O wiring connected to multiple devices.

Protective bonding: electrical connection of accessible conductive parts

or protective screening to provide electrical continuity to the means for

connection of an external protective conductor.

Bekijk gratis de handleiding van Schneider PowerLogic HDPM6000, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.