Schneider Altivar 61 VW3A3319 handleiding

Niet gecategoriseerd

Schneider

38 pagina's

PDF beschikbaar

Handleiding

8 1765274 08/2012

6. Quick start

Operation Refer to

A How to realize a factory setting of the drive

In the menu:

[1 DRIVE MENU]

[1.12 FACTORY SETTINGS]

• Select [Config. Source]: Macro-conf,

• Select [PARAMETER GROUP LIST]: All

Programming manual

[1.12 FACTORY SETTINGS]

(FCS-)

B How to configure main BACnet communication parameters:

In the menu:

[1 DRIVE MENU]

[1.9 COMMUNICATION]

[BACnet]

• Check [Address] (BACnet MAC address)

• Configure [Bit rate]

• Configure [Instance number] (also called "Device node ID")

•

You must power cycle the drive to apply these parameters to the BACnet card.

7. Configuration

7. 1. Communication parameters

C How to configure control is from BACnet

In the menu:

[1 DRIVE MENU]

[1.6 COMMAND]

• Change [Ref.1 channel] from "AI1" to "Com. card"

7. Configuration

7. 3. Control

D Handle the drive by the BACnet controller

• Control the velocity setpoint by the analog value INPUT REF 1,

• Control start / stop by the binary value RUN/STOP CMD,

• Control direction of rotation by the binary value FWD/REV CMD,

• Monitor if the drive is controlled local or remote (BACnet) by the binary value HAND/AUTO ACT,

• Monitor the running / stopped state by the binary value RUN/STOP ACT,

• Monitor the actual direction of rotation by the binary value FWD/REV ACT,

• Monitor the actual speed or frequency by the analog value OUTPUT SPEED or ACTUAL FREQ.

Note: send first the reference (INPUT REF 1) before sending (RUN/STOP CMD) in order to start

the drive.

Fault handling:

• Monitor the fault state by the binary value FAULT ACT,

• Monitor the fault detail by the analog value LAST FLT,

• Remote reset the fault by the binary value FAULT RESET.

E Switch local / remote by the drive HMI

Press F4 key (marked TK) to switch alternately from between BACnet and HMI.

The right of the upper display line:

- REM: control by BACnet,

- LOC: control by HMI.

Programming manual

Graphic display terminal

Description of the graphic screen

F Diagnose BACnet communication by the drive HMI

In the menu:

[1 DRIVE MENU]

[1.2 - MONITORING]

[COMMUNICATION MAP]

[DIAG NETWORK]

• Monitor the frame and error frame counters.

8. Diagnostics

8. 3. Control - Command

G Diagnose BACnet communication by the drive HMI

In the menu:

[1 DRIVE MENU]

[1.2 - MONITORING]

[COMMUNICATION MAP]

• Check that the Command Channel is Com. card,

• Check that Active ref. channel is Com. card.

8. Diagnostics

8. 9. Communication

H Disable network fault for testing

In the menu:

[1 DRIVE MENU]

[1.8 FAULT MANAGEMENT] (FLt- )

Configure [COM. FAULT MANAGEMENT] to [Ignore].

Programming manual

[1.8 FAULT MANAGEMENT]

(FLt-)

Bekijk gratis de handleiding van Schneider Altivar 61 VW3A3319, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.