Scheppach AWH-500BL handleiding
Handleiding
Je bekijkt pagina 23 van 212
www.scheppach.com
GB
|
23
6. Commissioning
m ATTENTION! Always make sure the product is fully
assembled before commissioning!
m ATTENTION! Only use the automatic welding hel-
met with the built-in rear panel (9).
m ATTENTION! Keep the sensors (13) of the UV/IR
lter (10) clean and clear.
m Before each use check that the automatic welding
helmet and the protective panel are intact. If the pro-
tective panel exhibits scratches, cracks or unevenness,
it must be replaced before use, otherwise serious inju-
ries may occur.
• Remove the protective lm from the inside and out-
side of the visor.
6.1 Adjusting the upper headband (Fig. 2)
To adjust the height, slide the strap apart or together
and snap the pin into the corresponding hole (see po-
sition B).
6.2 Adjusting the rear headband (2) (Fig. 2)
Note: The rotary knob (3) on the back is locked until it
is pressed in.
After unlocking, turn the rotary knob (3) clockwise to
tighten the headband and anti-clockwise to loosen it
(see position A).
6.3 Adjusting the viewing angle (Fig. 2)
To adjust the viewing angle, loosen the rotary knobs
(4) on both sides of the helmet and position the angle
lock on the right-hand rotary knob (4) to the desired tilt
position (5 positions, in the centre by default). Tighten
the rotary knobs (4) as soon as the desired angle is
reached. It should still be possible to swing the helmet
upwards, but it should not lower when it is put on for
welding (see position C).
6.4 Adjusting the distance (Fig. 2)
To adjust the distance between the user’s face and the
lter cassette (ADF lter) (8), loosen the knobs (4) on
both sides of the helmet until the headband (2) can be
moved freely forwards and backwards. Position the
headband (2) in one of the three slots for the desired
position (in the centre by default). This should be done
on both sides to ensure that the automatic darkening
lter works properly.
Safety instructions for handling batteries
1. Always make sure that the batteries are inserted
with the correct polarity (+ and –), as indicated on
the battery.
2. Do not short-circuit batteries.
3. Do not charge non-rechargeable batteries.
4. Do not overcharge batteries!
5. Do not mix old and new batteries or batteries of dif-
ferent types or manufacturers! Replace an entire
set of batteries at the same time.
6. Immediately remove used batteries from the
device and dispose of them properly! Do not
throw batteries away with household waste.
Defective or used batteries must be recycled in ac-
cordance with Directive 2006/66/EC. Return bat-
teries and / or the device via the collection facilities
provided. You can nd out about disposal options
from your local or municipal authority.
7. Do not allow batteries to heat up!
8. Do not weld or solder directly on batteries!
9. Do not disassemble the batteries!
10. Do not allow batteries to deform!
11. Do not throw batteries into re!
12. Keep batteries out of the reach of children.
13. Do not allow children to replace batteries without
supervision!
14. Do not store batteries near re, ovens or other
sources of heat. Do not use batteries in direct sun-
light or store them in vehicles in hot weather.
15. Keep unused batteries in the original packaging
and keep them away from metal objects. Do not
mix unpacked batteries or toss them together! This
can lead to a short circuit of the battery and thus
damage, burns or even the risk of re.
16. Remove batteries from the device when it will not
be used for an extended period of time, unless it is
for emergencies!
17. NEVER handle batteries that have leaked without
appropriate protection. If the leaked uid comes
into contact with your skin, the skin in this area
should be rinsed o under running water imme-
diately. Always prevent the uid from coming into
contact with the eyes and mouth. In the event of
contact, please seek immediate medical attention.
18.
18. Clean the battery contacts and corresponding
contacts in the device prior to inserting the bat-
teries.
Bekijk gratis de handleiding van Scheppach AWH-500BL, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Scheppach |
| Model | AWH-500BL |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 28998 MB |
