Rothenberger ROBEND 4000 E handleiding
Handleiding
Je bekijkt pagina 25 van 268
ENGLISH
19
Before commissioning the charger, ensure that the air slots are free. Minimum
distance to other objects is 5 cm/ 2"!
Self-test:
Insert mains supply plug.
The warning display (4) and the operating indicator (3) light up one after the other for approx. 1
second and the installed fan runs for approx. 5 seconds.
Battery pack:
Charge the battery pack before use (1).
If performance diminishes, recharge the battery pack.
The ideal storage temperature is between 10°C / 50° F and 30°C / 86° F. The permissible stor-
age temperature is between 0°C and 50°C / 32° - 122° F.
Li-ion battery packs have a capacity and signal indicator: (6)
Press the button (5), the LEDs indicate the charge level.
If one LED is flashing, the battery pack is almost flat and must be recharged.
Handling
Charging battery pack:
Push the battery pack completely to the stop on the sliding seat (2).
The operating indicator (3) flashes.
Conservation charge:
Once the charging process has finished, the battery charger automatically switches to conserva-
tion mode.
The battery pack can remain in the battery charger and is therefore always ready for use.
The operating display (3) lights up continuously.
Fault:
● Warning display (4) lights up continuously.
Battery pack is not charged. Temperature too high/ too low. When the temperature of the battery
pack is between 0 °C and 50 °C / 32° - 122° F, the charging process begins automatically.
● Warning display (4) flashes.
Battery pack is defective. Remove the battery pack immediately from the charger.
The battery pack was not pushed correctly onto the sliding seat (2).
5 Care and Maintenance
ROBEND 4000 E:
Remove the battery prior to carrying out any work on the machine.
Check that the machine switch unblocks automatically when finger pressure is released. In case
of any anomaly, replace immediately with a new one.
Change grease every 500 operating hours. After dismounting the machine, oil all mechanisms to
eliminate old grease. Remove parts with dry compressed air and apply new grease with clean
hands. Do not use any dissolvents. Approximately 300 grs. of grease is needed for a correct lu-
brication. An excessive amount of grease is not recommended as it can increase the tempera-
ture of the machine. Grease type: LGMT2 by SKF or similar. We recommend that this operation
be carried out by an authorized after-sales service.
Machine maintenance and repair should be done by a specialist.
Bekijk gratis de handleiding van Rothenberger ROBEND 4000 E, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Rothenberger |
| Model | ROBEND 4000 E |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 33257 MB |
