Rothenberger ROBEND 4000 E handleiding
Handleiding
Je bekijkt pagina 24 van 268
18
ENGLISH
4.2 Changing the battery (B-1)
Slide the battery in until you hear it lock into place. Remove the battery by pressing down on the
lock and then pulling the battery out.
Using a battery with at least 4.0Ah is recommended to ensure the optimum processing of pipes
with large diameters. Otherwise, the device’s power might be insufficient and the device will
switch off during the operating cycle.
4.3 Commissioning (B-2)
The unit provides a device for setting the bending angle automatically from 0º to 180º.
Loosen the graduated scale surrounding the former shaft and align the desired angle.
The machine is now set up and ready for use.
4.4 Operation (C)
For all bending applications, carefully follow the
steps described!
Select the tube or pipe to be bent. Choose the relevant bending former and shoe suited to
the tubes size.
Ensure that the ROBEND 4000 E is set in the start position by starting the motor with the di-
rection lever in the reserve position until it triggers off and moves to the neutral position.
Place the bending former onto the centrepin. Lay the tube into the bending former and se-
cure it into the hook.
Ensure that the tubes is fully inserted into the hook and has contact with the whole
hook surface
.
Secure the bending shoe with the fastening bolt into the appropriate housing.
Ensure you are at the correct starting position by checking the “0” mark on the bending for-
mer is lined up with the centre of the bending shoe.
To start bending, shift the direction lever to the working position and push the power switch.
The bending former will start to rotate.
Maintain pressure on the switch until your chosen angle of bend (marked on the bending
former) lines up with the mark on the bending shoe, and then release the switch.
The ROBEND® 4000 is equipped with a device that allows you to preset the bending angle be-
tween 0 to 180 degrees which is ideal for repeat bends. See “preparation for start up”.
Once the been has bend produced and the power switch has been released, shift the direc-
tion lever back into the reverse position. Briefly push the power switch to loosen the hold on
the tube. Once the tube has released you can remove the fastening bolt, then the bending
shoe and finally take the finished bend out of the bending former.
In order to make the ROBEND 4000 E ready for the next bending operation, start the motor
with the direction lever in the reverse position until it triggers off and moves into the neutral
position.
4.5 Charger and battery (D)
Overview:
1 Battery pack 4 Warning display
2 Sliding seat 5 Capacity indicator button
3 Operation display 6 Capacity and signal indicator
Start of operation
Before plugging in, check to see that the rated mains voltage and mains frequency,
as specified on the rating label, match your power supply!
Devices such as this one, which generate direct current, may have an effect on basic residual-
current circuit breakers. Use type F or better, with a release current of max. 30 mA.
Bekijk gratis de handleiding van Rothenberger ROBEND 4000 E, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Rothenberger |
| Model | ROBEND 4000 E |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 33257 MB |
