Rommelsbacher CT 2002/IN handleiding
Handleiding
Je bekijkt pagina 27 van 32
27
• For activating the timer, touch the timer sensor (2)
The appliance automatically switches into the opera-
ting time mode. The display (4) shows
, the LED
timer (8d) is lit continuously
NOTE: If there is no further activation within 5 seconds after activating the operating time,
the control will switch back to the normal cooking mode without timer.
• By touching the + sensor (3) you can in-crease the
operating time in minute intervals up to 3 hours (180
minutes).
• By touching the – sensor (5) you can reduce the ope-
rating time in minute intervals.
• By continuously pressing the + sensor (3) or – sensor
(5) you can increase or reduce the operating time in
10-minute intervals.
• Starting with the – sensor (5) the display com-
mences with 3:00 (180 minutes). By touching this
sensor again you can reduce the operating time.
On the display (4) the adjusted operating time e. g. 1:15 (1 hour, 15 minutes) is indicated.
About 5 seconds after setting the timer the display switches back to the initial function.
When touching the senor timer (2) again, the display (4) shows the active remaining
operation time for approximately 5 seconds; now the timer can also be adjusted once
again. Once the set time has elapsed there is a short audible signal and the control auto-
matically switches over to standby mode.
NOTE: Changing the power or temperature level will not affect the time set.
Setting the operating time (timer) – reset function
Touching the timer sensor (2) for 3 seconds during active operating time mode (timer), the
timer display gets reset to the value 0:00 and the set time is not active any more. In this
case there will be no automatic switch-off and the appliance keeps on working.
Switching-off
For switching-off, touch the main switch (1). The display now shows the residual heat of the
hob. If the temperature is above 60 °C, the display shows ,, if the temperature is lower .
The control unit is now in standby mode.
NOTE: If the waste heat of the pot creates a temperature on the cooking zone of more than
60 °C the LED heat (8a) is lit. As soon as the temperature has sunk below 60 °C, respectively
the unit is disconnected from the mains the LED heat (8a) expires.
NOTE: It is normal for the fan to continue running in the standby mode after a long
operation time.
OUR ADVICE: Electrical appliances featuring a standby mode consume
some power also in non-operating state. Save energy by disconnecting your
appliance from the mains after the fan has stopped or during non-use periods
by pulling the mains plug.
Bekijk gratis de handleiding van Rommelsbacher CT 2002/IN, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Rommelsbacher |
| Model | CT 2002/IN |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 2712 MB |
