Roborock Q7T+ handleiding
Handleiding
Je bekijkt pagina 9 van 52
09
Turn on the robot, then press and hold
and simultaneously for three seconds
until you hear the “Entering network
configuration mode” voice message. The
reset is complete when the power indicator
light flashes wihte slowly. The robot will
then wait for a connection.
2. Reset WiFi
Instructions for Use
Open the Roborock app, tap the “Add
Device” or “+” button and add your device
following the in-app guide.
Notes:
• The actual process may vary due to ongoing app
updates. Follow the instructions provided in the app.
• Only 2.4 GHz WiFi is supported.
Notes:
• Before cleaning, tidy cords (including the power cord
of the dock) and valuables from the floor. Loose
items may be dragged by the robot, resulting in the
disconnection of electrical appliances or damage of
cords and property.
• Before starting each cleaning task, make sure that the
mop cloths have been properly installed.
• To make sure the robot returns to the dock
automatically, start the robot from the dock and do
not move the dock during cleaning.
• Cleaning cannot start if the battery level is too low.
Allow the robot to charge before starting a cleanup.
3. Add device
Note: The robot cannot be turned off when it is being
charged.
Press and hold to turn on the robot. The
power indicator light will come on, and the
robot will wait for orders.
Press and hold to turn off the robot and
complete the cleaning cycle.
Turning On/Off
Press to start cleaning. The robot will plan
its cleaning route and in each room, it firstly
draws out edges and then fills the room in a
zigzag pattern. In so doing, the robot cleans
all rooms one by one, thoroughly and
efficiently.
Starting Cleaning
Notes:
• The robot will not go to sleep when it is charging.
• The robot will automatically shut down if left sleep for
more than 12 hours.
If the robot is paused for over 10 minutes, it
will go to sleep, and the power indicator
light will flash every few seconds. Press any
button to wake the robot up.
Sleep
When the robot is running, press any
button to pause it, press to resume
cleaning. Press on a paused robot to
send it back to the dock for charging.
Pause
Note: Placing a paused robot on the dock manually will
end the current cleanup.
After cleaning, the robot will automatically
return to the dock for charging. During
cleaning, the robot will return to the dock to
charge when the battery level is low. Press
to send the paused robot back to the dock.
The power indicator light will breathe during
robot charging.
Charging
Note: If the robot fails to find the dock, it will
automatically return to its starting position. In this case,
place the robot to the dock manually to charge.
Connecting to the App
Search for “Roborock” in the App Store or
Google Play or scan the QR code to
download and install the app.
1. Download the App
Notes:
• If you cannot connect to the robot due to your router
configuration, a forgotten password, or any other
reason, reset the WiFi and add your robot as a new
device.
• If you want to disconnect WiFi, reset the WiFi and make
sure the WiFi is successfully resetted. Then wait for 5
minutes and WiFi will be automatically disabled. lf you
want to reconnect, reset the WiFi before proceeding.
• If the battery runs low during a cleaning cycle, the
robot will automatically return to the dock. After
charging, the robot will resume where it left off.
Bekijk gratis de handleiding van Roborock Q7T+, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Roborock |
| Model | Q7T+ |
| Categorie | Stofzuiger |
| Taal | Nederlands |
| Grootte | 4407 MB |
