Handleiding
Je bekijkt pagina 8 van 16
6
Operating Instructions
First Time Usage
IMPORTANT: You should clean the ceramic hob surface (see “Maintenance and cleaning”
section).
Turn each element on, one at a time, and leave them to run at full heat for five minutes. This will
help to eliminate any new smell that exists and evaporate any humidity that has formed on the
heating elements during transit. Only do this for one element at a time. Place a saucepan half
filled with cold water on the element during this process.
Operation
POWER ON
After switch on the appliance, the hob will beep for once to remind power on, all of the indicator digital tubes on the
display screen will lit on for 2s, then the appliance goes into shutdown mode. Note: If your hob with multi-ring, the
corresponding indicator digital tube decimal point “ ” will lit on. If your hob with single ring only, the digital tube
decimal point “ ” will not lit on.
SHUTDOWN STATUS
All the display will close except the high temperature warning symbol “ ”; At this time, only the power button
“ ” can operated by pressing and holding, and other button operations are invalid.
STANDBY MODE
• Under shutdown status, press and hold “ ” button for 3s, the hob will beep for once and then enter
standby mode.
• All the indicator digital tubes of the cooking zone will display “ ”(The symbol “ ” will show in the
cooking zone indicator if there is residual heat), timer place will show “ ” as well, it will not heat at
this time.
• Under standby mode, if no cooking zone heating operation, the appliance will go into shutdown status
automatically after 10s and beep once.
HEATING CONTROL
• Under standby mode, you can choose the cooking zone by pressing the cooking zone select button, then
press plus or minus button to adjust the power level of the corresponding cooking zone. Press and hold plus
“ ” or minus “ ” buttons can continuously to increase or decrease the power level.
• When the hob top is in heating status, press and hold “ ” power button for 3s to switch off, and stop all the
cooking zones to heat. The corresponding cooking zone indicator of the hob top which has heated before will
display high temperature warning symbol “ ”.
• Under standby mode, if some hob tops still exist residual heat, display will show “ ”.
• If needing to switch off one of the cooking zones, you can select that zone first, then press the minus button
“ ” until “0” power level to switch off that zone and will not affect the heating of the other cooking zones.
When power level reaches “0”, the corresponding cooking zone indicator of the hob top which has heated
before will display high temperature warning symbol “ ”.
• If more than one zone is operating at the same time, total power will equal to the sum of the powers of all
the working cooking zones, each cooking zone will work according to their power modulation ratio and will
not affect each other.
Note:
• During the same period, only one hob top button is valid, that is only one decimal point can be
displayed.
• Press minus button “ ”to set the power level to “0”, then the heating hob top will close automatically.
Bekijk gratis de handleiding van Robinhood HEF302TCOM, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Robinhood |
| Model | HEF302TCOM |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 2606 MB |