RIDGID 918-5 handleiding
Handleiding
Je bekijkt pagina 9 van 111
7
918 Roll Groover
999-998-946.10_REV D
7
Figure 6 – Warning Labels
Machine and Work Area Set-up
WARNING
Set up the roll groover and the work area according
to these procedures to reduce the risk of injury
from machine tipping, crushing and other causes,
and to help prevent machine damage.
Be aware of the equipment weight. Use appropriate
methods when lifting or moving.
Secure roll groover to power drive or threading
machine. Properly support pipe. This will reduce
the risk of falling pipe, tipping and serious injury.
1. Locate a work area that has the following:
• Adequate lighting.
• Clear, clean, level, stable and dry place for all
equipment and operator. Clean up any oil that may
be present.
2. Inspect the pipe to be grooved and determine the
correct tool for the job, see Specifications. Grooving
equipment for other applications can be found in the
RIDGID catalog online at RIDGID.com. Do not use
to groove anything other than straight stock. Do not
groove pipe with protrusions or outlets such as Tees
or elbows. This increases the risk of entanglement.
3. Confirm all equipment to be used has been properly
inspected and assembled. Confirm that the correct
grooving roll set is installed in the roll groover for the
application.
Use of roll sets (groove roll and drive roll)
on both carbon and stainless steel pipe can lead to
Pre-Operation Inspection
WARNING
Do not use this roll groover with a power drive/-
hreading machine that does not have a foot switch.
Before each use, inspect your roll groover and
correct any problems to reduce the risk of serious
injury from crushing injuries and other causes and
prevent roll groover damage.
1. If installed on a machine, place the machine switch in
the OFF position and unplug.
2. Clean any oil, grease or dirt from the roll groover,
including the pump handle and stabilizer crank
handle. This aids inspection and helps prevent the
machine or control from slipping from your grip.
3. Inspect the roll groover for the following:
• Proper assembly, maintenance and completeness.
• Broken, worn, missing, misaligned or binding parts.
• Hydraulic leaks. Oil on the groover can indicate a
hydraulic leak.
• Presence and condition of the guard (See Figure 1).
Do not operate the roll groover without the guard.
Guard should freely move between settings and
securely stay in place.
• Presence and readability of the warning labels (see
Figure 6).
• Condition of the groove roll and drive roll. If the
drive roll knurls are dirty, clean with a wire brush.
Dirty or worn knurls can cause pipe slippage and
tracking issues during grooving.
• Condition of the stabilizer wheel. Replace if needed.
• Any other condition which may prevent safe and
normal operation.
• If any issues are found, do not use the roll groover
until the issues have been repaired.
4. Inspect and maintain any other equipment being
used per its instructions to make sure it is functioning
properly. Confirm that the Power Drive or Threading Ma-
chine has a foot switch in good working condition.
NOTICE
Bekijk gratis de handleiding van RIDGID 918-5, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | RIDGID |
| Model | 918-5 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 42226 MB |
