RIDGID 918-5 handleiding
Handleiding
Je bekijkt pagina 10 van 111
918 Roll Groover
999-998-946.10_REV D
8
contamination of the stainless steel material. This
contamination could cause corrosion and prema-
ture pipe failure. To prevent ferrous contamination
of stainless steel pipe, use roll sets dedicated for
stainless steel grooving. Alternately, a stainless steel
wire brush can be used to thoroughly clean the roll
set when switching between materials.
4. Set up the Power Drive or Threading Machine per
its instructions in the flat level area. Confirm that the
REV/O-OFF/FOR switch is in the OFF position.
If using the 918 with a 535A (Auto Chuck) machine, it
is recommended that the machine be configured for
the chuck jaws to grip the pipe during REV rotation
of the machine. This allows the stabilizer to be used
when grooving. See the 535 Auto Chuck Manual,
Left Hand Threading section for information on con-
figuring the chuck jaws to grip the pipe during REV
rotation of the machine.
5. Install 918 on Power Drive/Threading Machine –
see section for setting up on specific equipment.
Confirm that the equipment is secure and stable.
6. Position the foot switch for proper operation as
shown in Figure 19.
7. After the 918 is properly installed, with dry hands,
plug machine into appropriate outlet per its instruc-
tions.
Installing 918 On 300 Power Drive
1. Confirm 918 and base are properly assembled.
2. Remove carriage or other attachments from the
support arms of the 300 Power Drive. Confirm that
the power drive support arms are fully extended and
fixed in position.
3. Fully open front chuck of power drive.
4. Slide the opening in the base (stabilizer side) over
the rear support arm and lower the pump to the front
support arm (Figure 7A).
5. Move the base toward the 300 Power Drive
6. Center drive shaft in the machine chuck. Align the
drive shaft flats with the machine chuck jaws.
7. Securely tighten the front chuck on the flats of the
drive shaft. See Figure 7B.
Figure 7A – Installing 918 on 300 Power Drive
Figure 7B – Securing Drive Shaft In Chuck
Installing 918 On 300 Compact/1233
Threading Machines
If the 300 Compact or 1233 threading machines are
mounted on straight pipe legs into the machine base, do
not use with the 918 roll groover. The set up may not be
stable enough for grooving forces. Pipe legs with feet that
provide improved stability (Catalog # 56532) are available
for this use. See Figure 8A for proper orientation of the
legs. The 10 mm bolts will go through the holes in the leg
to properly orient the foot of the leg.
The 918 Roll Groover cannot be used with machines
mounted on the 250 Folding Stand. The stand handle
interferes with the pipe being grooved. The 918 with the
Bekijk gratis de handleiding van RIDGID 918-5, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | RIDGID |
| Model | 918-5 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 42226 MB |
