RIDGID 918-5 handleiding
Handleiding
Je bekijkt pagina 22 van 111
918 Roll Groover
999-998-946.10_REV D
20
Troubleshooting
PROBLEM POSSIBLE REASONS SOLUTION
Groove too narrow or
too wide.
Incorrect groove roll and drive shaft. Install correct groove roll and drive shaft.
Groove roll and/or drive shaft worn. Replace groove roll and/or drive shaft.
Mismatched groove roll and drive shaft.
Install matching roll set.
Rolled groove not
perpendicular to pipe
axis.
Pipe length not straight. Use straight pipe.
Pipe end not square. Cut pipe end square.
Pipe does not track
while grooving.
Groover will not track
on pipe while groov-
ing.
Pipe and drive shaft not parallel.
Adjust stand to make pipe parallel.
Pipe axis not offset
1
/
2
degree from drive roll axis. Offset pipe
1
/
2
degree.
1
/
2
degree offset not sufficient. Offset pipe slightly more.
Drive shaft/roll knurl plugged or worn flat. Clean or replace drive shaft/roll.
Inside of pipe has too much scale.
Clean inside of pipe.
Excessive weld seam. Grind weld seam flush 2" from end of pipe.
Not using/properly adjusting stabilizer. Adjust stabilizer. Apply pressure to pipe (see Figure 20/21).
Pipe end not square/deburred.
Properly prep end of pipe
.
Pipe flared at grooved
end.
Pipe and drive shaft not parallel.
Adjust stand to make pipe parallel.
Operator is advancing groove roll too fast. Slow down pumping action. Refer to Operating instructions.
Pipe is too hard. Replace pipe.
Stabilizer too tight. Adjust stabilizer.
Pipe drifts back and
forth on driving shaft
axis while grooving.
Pipe length not straight
Use straight pipe
.
Pipe end not square
.
Cut pipe end square.
Pipe rocks from side
to side.
Pipe stand too close to end of pipe
.
Move pipe stand in to match set-up Instructions.
Pipe end flattened or damaged
.
Cut off damaged pipe end
.
Hard spots in pipe material or weld seams
harder than pipe.
Use different pipe
Groove roll feed rate too slow. Feed groove roll into pipe faster.
Pipe supports stand not in correct location. Position pipe stand rollers correctly.
Power drive/threading machine speed exceeds
57 rpm.
Reduce speed to 57 rpm.
.
Groover will not roll
groove in pipe.
Maximum pipe wall thickness exceeded. Check Table I.
Pipe material too hard. Replace pipe
Adjustment nut not set. Set depth.
Wrong roll set. Install correct roll set.
Groover will not roll
groove to required
diameter
Maximum pipe diameter tolerance exceeded. Use correct diameter pipe.
Depth adjustment nut not set correctly. Adjust depth setting.
Pipe too hard. Use different pipe.
Pipe slips on drive
roll.
Groove roll feed rate too slow. Feed groove roll into pipe faster.
Drive shaft knurls plugged with metal or worn
flat.
Clean or replace drive roll.
Pipe raises or tends
to tip Groover over
backwards.
Pipe support stand not properly set up. Properly set up stands.
Bekijk gratis de handleiding van RIDGID 918-5, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | RIDGID |
| Model | 918-5 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 42226 MB |
