Handleiding
Je bekijkt pagina 45 van 72
45
The correct routing of the gas supply hose is shown in Fig. XII
1. Power cord
2. Gas supply hose
3. Clamp
ATTENTION!
Each time you connect the appliance to gas cylinder, check the tightness of the cylinder valve and the
connection of the reducer with cylinder and its operation.
ATTENTION!
1. It is unacceptable to check tightness using an open flame (e.g. a match or light up). There is a risk of
explosion! You can use soapy water to check for leaks
2. Periodically check the condition of the hose and the tightness of the connection, in accordance with
applicable regulations
3. The rubber hose should not touch hot appliance elements.
ATTENTION! CONNECTION BY RUBBER HOSES COMPLIANT WITH CURRENT REGULATIONS
IS ONLY ALLOWED IF THE ENTIRE LENGTH OF THE HOSE IS POSSIBLE TO CONTROL
The device is made in the second category and can operate on two types of gas II2E3B/P.
By default, the device is set to gas from family 2.
2E – high-methane natural gas GZ20 - 20mbar (factory setting).
The device can be powered by gas from family 3: 3B/P – propane butane.
In order to adapt the device to propane-butane (PB/P) gas, the nozzles must be replaced.
REPLACING NOZZLES
To replace the nozzles:
1. Wait until the appliance cools down
2. Remove the grate
3. Remove the burner caps
4. Unscrew the nozzles using a socket wrench "7" and replace them with nozzles adapted to
the feed gas
5. Install the burner caps and grate
Bekijk gratis de handleiding van Ravanson KWGE-90R, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Ravanson |
| Model | KWGE-90R |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 13051 MB |
