Handleiding
Je bekijkt pagina 43 van 72
43
CLEANING AND MAINTENANCE
Before cleaning, check that all knobs are set to "off".
Please wait until the device cools down.
For cleaning, use a damp (not wet) cloth with a mild detergent.
Do not use scouring agents, corrosive agents or sharp objects for cleaning and materials.
CHANGE OF A LIGHT BULB – se Figure . XIV
ATTENTION! Before replacing the bulb, disconnect the device from the power source!
To replace the bulb, unscrew the cover (A), replace the bulb (B), put the cover back on.
Bulb parameters:
Rated voltage: 220 – 240 V
Rated power consumption: 25W
Rated frequency: 50 Hz
Cap: E 14
TRANSPORT AND STORAGE
Transport and store the device in its original protective packaging it against mechanical damage, moisture and
dust.
ATTENTION! Do not move the kitchen by holding the oven handle
INSTRUCTIONS FOR THE INSTALLER
Connecting and adapting the device to the appropriate type of gas can be performed by a gas equipment
installer with appropriate qualifications only, in accordance with applicable regulations.
After carrying out the above-mentioned activities, the installer should indicate in the TECHNICAL DATA table in
the warranty card the type of gas for which the appliance has been adapted.
The manufacturer is not liable for damage resulting from failure to comply with applicable standards and
regulations or connecting the device by an unauthorized person!
Remove the packaging and place the appliance in a dry, well-ventilated room. away from curtains. Do not store
paper, alcohol, gasoline, etc. near the appliance.
The connection must be made in accordance with applicable standards and regulations!
The appliance is adapted to be powered by gas with the parameters specified on the rating plate. Check
whether the given gas characteristics correspond to the parameters of the feed gas.
The appliance is equipped with a pipe connector with a G½" thread. Connect the gas to the spigot using
appropriate accessories.
The appliance can be connected to the internal home installation or to a liquefied gas cylinder.
Before starting the connection, the gas tap must be closed.
CONNECTION BY FLEXIBLE HOSE
ATTENTION!
Connection using a flexible hose can only be made after checking whether it’is compatible with applicable
regulations.
Bekijk gratis de handleiding van Ravanson KWGE-90R, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Ravanson |
| Model | KWGE-90R |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 13051 MB |
